20 Most Recent
HP LaserJet 4350 Printer - Page 2 Questions & Answers
Print fading down right hand side
I was able to fix it by taking off the top of the printer. This involved taking off 4 screws on the top of the printer. I then had to disconnect the wires going to the control panel by unhooking them from the right side. I then located a thin rectangular box which I'm assuming houses the laser. I removed this with 4 more screws and turned it over. There was a little metal flap that I moved back and below was the mirror the lasers shoot on before going onto the toner.
In the same spot where I was having fading, I noticed a lot of toner on the mirror, so I cleaned it of, put it back together, and the fading was gone.
This was after I tried a new toner and maintenance kit.
Hope this helps
Paper jam in tray 2 but there is nothing jammed.
Paper not being picked up, does it have a 3rd tray, take all paper out of tray 2 and see if you can get paper to feed from 3. Also make sure the lever on the cassette tray is in the normal position and check the menu in the settings. Some times the front registration area above the cassettes goes bad, not very common but does happen...place som toner on the wheels in tray two and try to print, see if the toner rubs onto the paper, if it does means wheels are turning, if not wheels are not turning....
49.ff04 service error
Check and remove the HDD and try it for a while. Replace the jet direct card and try (if you have one installed) and try. Update the firmware. If that fails then someone is sending a corrupt file\print job to the printer.
Hp laser jet 3005 printer clearing paper path error
I would pull out the paper tray, and clean the underside roller. First try to clean it without moving the clips. Use a cotton cloth or lint free cloth and alcohol. Get as much paper dust off as you can. This might help you out.
49.1643 Service error
Go to hp webite and download resent firmware and that should fix it. Just for kicks, change the toner cartridge out. I saw one causing 49 errors because the gears were locked up, causing gears no to turn. Good luck
Not finding what you are looking for?