Which model freezer do you have?
A few possible resets: press and hold the Set and + keys for 5+ seconds. On some models, that will get the freezer out of demo mode. On other models, it's the Set and Down arrow. For a few models, it's the Options and Up arrow. In all cases, it's press and hold both buttons until the unit responds.
I hope you will add a comment with the model of your freezer so that I can determine which set of instructions will work for your unit.
Cindy Wells
? 7:02www.youtube.com/watch?v=gVXT7pZyk_oSep 12, 2013 - Uploaded by ApplianceVideo.com
Service a Kenmore Upright Freezer which has the following problems: Not Cooling Properly At: http ...
www.realestate.com > Realestate.com Blog > Articles
Aug 12, 2012 - Alternatively, if the freezer is in a defrost cycle, it will not kick on immediately, the temperature ... Refrigerant circulates through coils, spreading coldthrough the unit interior before .... We have a kenmore upright deep freezer.
I am Taking a guess at this. May or may not work. Have you tried unplugging the unit?, and leaving it unplugged for 5 or 10 minutes? I have noticed with everything these days having electronics involved, severing power often resets everyuthing to a default position. You might try it if you haven't already.
also, there should be in the owners manual an 800 number
to call for assistance from the mfr.thwy usually have a tech you can talk to. good luck!
Hello;My name is Peter. I am a retired field service refrigeration technician.The normal cycle is: Your compressor will turn on to raise the freezer temperature 20 degrees F. above the set temperature, and then the compressor will shut off, Until the freezer temperature drops 20 degrees F. below the set temperature and again the compressor will turn on.One of the main problems with this type of freezer is the door gasket becomes crushed over time or the door is so thin it becomes deformed.Do not try to replace the door gasket. You have to soak the new gasket in hot water for 1/2 hour and then form it on the door.If you notice a gap in the corner of the door - pull hard on it to get it flush.Recondition the door gasket - With a hair dryer and a kitchen spatula, heat the gasket and try to expand the gasket by pulling out with the spatula. You can purchase a special freezer lubricant. Be sure not to over do it. It can make the door hard to open. P/N 5426381/2 Oz. $12.00.
