20 Most Recent Amana 3.5 cu. ft. Front Load Washer - Page 5 Questions & Answers

Best guess: replace the thermistor-the water temperature sensor. Try a cold water only wash and see if that works. If it does, then the thermistor is probably it.

come on buy lid lock s/w put it in

I would check for a missing sock or hanky etc stuck in one of the hoses. Its obviously not blocked enough to stop the machine from pumping out, but it may be slowing how fast the water comes out. Im not conversant with Amana but if its a belt drive, the belt may be slipping causing a poor spin result.

try re sitting the feet that normally works

Check and see if there is a cup in the top of the agitator. Some machines have you put it there, turning back and forth during wash doesn't bother it, but the spin to empty the wash water causes the softener to go out through slots in the top of the cup and be held in the agitator. when it stops the softener drains into the tub, ready for the rinse cycle.

https://www.partsimple.com/whirlpool-35001269-wp35001269-laundry-dryer-display-control-board.html

Try this link, maybe this is what your looking for

Hello there and welcome to fixya From what you're describing it sounds like the drain pump is blocked. The nd error code indicates "no drain". If the unit can't drain it won't spin. You're going to have to slide the washer out far enough to remove the rear panel; be careful not to damage the floor. Once you get the rear panel off you will see the pump. Be sure to have plenty of towels & a small container to catch water. I am sending you instructions from the service manual to remove and replace the pump. Another possibility is the drain line is blocked or something is stuck in the tub to pump hose.

What can I do if my machine doesn't work properly

LO or FL error is displayed if no water is entering the washer. Check to see if water valves are turned on and check in line filter screens at inlet to hoses. " https://www.6ya.com/callphilipforhelp

Once the bolt is removed, it should be able to just pull up. It may be tough but grab it from the base and pull up with some force. Carefull not to hit your face once you free it up.

check your wash program selection check tap on at cupboard

Unplug it for 10 minutes

I bought mine from circuit city in 1994 or 1995

Does the lid lock? Also Could be the motor. Also could be the actuator that shifts transmission from agitate to spin. Also could be belt issue. Or maybe something wedged between inner and outer tubs. Call a professional unless you’re comfortable with checking all this out.