20 Most Recent Sharp AR-M160 Laser Printer - Page 3 Questions & Answers

F5 mean copy lamp lighting abnormality.Problem betweem CCD

yes it does and for more information log on to www.printcountry.com

Check the correct instalation of the developing unit.

You problem in fuser heater

L1-
scanner feed trouble &
CH-
side door open

ch-
1.side door open
2.developing cartridge not installed
L1-
scanner feed trouble

chack the fusing units the thermistor is open
&thermistor abnormality chack the harness and the
connector between the thermistor and the pwb
use simulation mode(# interaput c interaput )
preas the 14 toclear the self diagnostc dis play

Have you cleaned the small, narrow glass window leftmost of the platen? It is directly above the scanning bar's "home" position, and that's where the document is scanned, while it's fed by the feeder, passing over the bar (the paper moves, as oposed to platen scanning, when the bar is moving and document remains still).

enter the simulation mode:
"#" key Interrupt key "C" key Interrupt key
press 14 and START key
the copier should restart in most cases.

if not:
There is a problem in the fusing area, bad Thermistor, defective ThermalFuse, defective heating lamp.

The cartridge is faulty, in most cases not a genuine cartridge. If the copier works with the old one that means the "new" cartridge in defective.
If you brought a original Sharp cartridge you should return that and ask for a new one.

the mcu bord is not working chack the mcu bord

i think the error your actually getting is F2. this error pertains to toner cartridge chip error. it's that little chip on at the end of the cartridge.you'll need to have that replaced.

Hi,

The error H and 4 blinking indicates that, You have a defective fuser unit.
H is for HEATER
You should replace youe heater unit, if your product falls in warranty period, you can avail wrranty..

ENJOY! RATE THIS SOLUTION
RNJ VINOD KUMAR

check the paper path.you should see black little trip levers,they work as paper sensors.if foreign object gets into those sensors,you will encounter that type of error.also,if the sensors are faulty,you get the same error.

reset code is c-photo-c-photo

L6 error on AR-M160 - Polygon motor problem.

I would suggest repairman service for this one as it requires stripping the unit down.

Try reseting the error first though.

"#" "interupt" "clear" "interupt" "1" "4" "start key"

It is now.

1. go to: http://support.sharp.net.au/drivers/
2. on the left hand side of the web page, you'll see photo copiers. click the arrow
3. scroll to the ARM160. Click the arrow.
4. select the 1st one: M205_PPD_0702a_Vistax32x64.zip

You might have to completely uninstall the old, reboot, then reinstall with the new driver.

It should work.

Good Luck!