20 Most Recent Roper 24 in. RUD4000M Built-in Dishwasher Questions & Answers

0helpful
1answer

How do I disconnect the electrical line from the dishwasher? It is hard wired into a box.

To avoid electrocution, call an electrican
9/7/2012 4:50:14 AM • Roper 24 in.... • Answered on Sep 07, 2012
0helpful
1answer

Water leaks at top &bottom of door only on

Hi,

Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101

3/8/2011 3:21:42 AM • Roper 24 in.... • Answered on Mar 08, 2011
0helpful
1answer

Roper dish washer not cleaning the dish, it is a

Hi,

The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.

Here is a tip that will help you to solve the problem of films, residue, and scum in your dishwasher.

Dishwasher Residue and Film on Dishes

heatman101


2/20/2011 7:39:07 PM • Roper 24 in.... • Answered on Feb 20, 2011
0helpful
1answer

Roper dish washer not cleaning the dish

Hi,



I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...


Dishwasher
Spray Arms not Spinning

How to Buy
Appliance Parts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The
Heating Element not Working

Dishwasher Maintenance



Dishwasher Residue and Film on Dishes



heatman101

2/20/2011 7:38:55 PM • Roper 24 in.... • Answered on Feb 20, 2011
0helpful
1answer

Water In Dishwasher Won't Drain

Hi,

Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - Water will not drain outheatman101

a

9/29/2010 2:31:43 PM • Roper 24 in.... • Answered on Sep 29, 2010
0helpful
2answers

Dishwasher did not drain all the water

Your sink drain is clogged and the back pressure is not allowing the dishwasher to drain competely. Do not use a liquide drain cleaner, it will damage your disposal. take apart p-trap hopefully the clog is there, otherwise the line will need to be snaked. I’m happy to help further over the phone at https://www.6ya.com/expert/josh_87ce33216d7b2148
9/29/2010 2:17:43 PM • Roper 24 in.... • Answered on Sep 29, 2010
0helpful
1answer

Copier - canon np6010

to stop this Bay chip reset software from ebay or another place for Canon

http://cgi.ebay.in/ws/eBayISAPI.dll?ViewItem&item=110521860863

its working and very low cost at just 2 dollers and 99 rupies
4/19/2010 12:09:19 PM • Roper 24 in.... • Answered on Apr 19, 2010
0helpful
1answer

Soap dispenser door doesnt open during wash cycle

I have had this problem on a dishwasher IF I overfilled with powdered detergent. It would cake and the door would not open. Now I always leave a little space.
3/27/2010 7:50:05 PM • Roper 24 in.... • Answered on Mar 27, 2010
0helpful
1answer

Roper RUD5750DB4 is leaking

Your problem could be the rubber door seal.
2/25/2010 2:10:48 PM • Roper 24 in.... • Answered on Feb 25, 2010
0helpful
1answer

We have had our dishwasher for quite a few years,

1)scaling in the boiler tank.(boiler tank to be cleaned)
2)water hardness is more.
1/9/2010 7:53:00 AM • Roper 24 in.... • Answered on Jan 09, 2010
0helpful
1answer

Water leaking through vent in door

Check your spray arm that nothing got stuck in its holes. make sure the spray arm is turning all the time when using the machine :
put the spray arm in 90 degree position, turn the unit on , open the door after few min check that the spray arm move...
make sure your seal of the door is clean and nothing prevent it to close evenly the door...
good luck 911servicetoday . com
1/3/2010 11:08:09 AM • Roper 24 in.... • Answered on Jan 03, 2010
0helpful
1answer

Dishwasher Detergent Dispenser not opening

An automatic dishwashermag-glass_10x10.gif detergent dispenser door can become stuck for a few different reasons. Some problems are easy to fix, while some require more work. Repairs are basically the same no matter what brand of automatic dishwasher you have, although specific parts might be required. Fortunately, even if the detergent dispenser needs to be replaced, the problem is not an emergency. The dishwasher will clean dishes fine even with a stuck detergent dispenser.
    Fixing a Stuck Automatic Dishwasher Detergent Dispenser
  1. Step 1 Move the basket that holds silverware as far from the detergent dispenser as possible, or make sure no tall items are blocking the dispenser. Also, keep other items such as plates and pans away from the dispenser. Anything that winds up touching the dispenser during the wash cycle can cause the dispenser door to stay closed. Run the dishwasher to see if this solves the problem.
  2. Step 2 Remove the front door panel according to your instruction manual, or find the manufacturer's instructions online, which will probably be in a PDF file. The panel is typically held on by 6 to 8 screws along the edge, which you can see when the door is open. With most models, you won't need to remove the screws at the bottom of the door, which are part of the hinge assembly.
  3. Step 3 Clean the detergent dispenser thoroughly from the inside of the dishwasher and the exterior side as well. Accumulated detergent and other material can interfere with the spring mechanism or halt the pivot action of the door. Use very hot water and a micro-sized brush. You also can use a mix of hot water and vinegar.
  4. Step 4 Most dispensers have a bimetallic strip or switch, attached by screws, which triggers the door release. With the front door panel removed, locate the switch, and push on it gently with a screwdriver until the dispenser door opens. You might simply need to adjust the alignment of the switch.
  5. Step 5 Purchase a new switch if re-aligning the old one does not fix the problem. Typically, these switches cost under $10. See Resources for a link to different manufacturers where you can buy the part.
  6. Step 6 Label the two wires connected to the switch so you can correctly reconnect them afterward, and then remove them from the terminals by holding the slip-on connectors --- not the wires --- and pulling firmly. Use a pair of needle-nosed pliers for a better grip. Then remove the switch from the dispenser by removing the screws holding it in place. Connect the wires to the terminals of the new switch, and attach the new switch to the detergent dispenser. Replace the door panel.
  7. Step 7 Run the dishwasher again to see if the switch replacement has done the trick. If not, decide whether to replace the entire dispenser according to the manufacturer's instructions, or call a repair technician.
11/14/2009 8:28:00 PM • Roper 24 in.... • Answered on Nov 14, 2009
0helpful
1answer

Roper Dishwasher leaks from float or float switch onto floor

you could be usiong way to mauch soap try filling only one of the soap trays or even try doing one wash without any soap at all
this unit tends to do this if you have to much soap in the unit left over from the last load...
beyond that your machine is proibaly tilted to far forward you can lift it, by lowering the front legs begind the toekick
10/25/2009 5:25:41 PM • Roper 24 in.... • Answered on Oct 25, 2009
0helpful
1answer

Roper dishwasher washes, seems to run normally,

If the drain is stoped this will happen. Is it a new instalation? If into a disposer did you knock out the plug in the disposer. Check the drain line
10/17/2009 2:25:36 PM • Roper 24 in.... • Answered on Oct 17, 2009
0helpful
1answer

Dishwasher on no water

Is the water valve under the sink on? Any kinks in the hose? Check to see if the water valve solenoid coil is open (located under the cabinet front).
10/12/2009 2:36:13 AM • Roper 24 in.... • Answered on Oct 12, 2009
0helpful
1answer

Dishwasher water level low and making strange noise.

Hi, This d/w is designed to run with low water level. The noise you are hearing might be the wash motor. Do you know if this has the single or dual motor setup?
The dual motor style are not the greatest. The wash motor is known to go bad. You can remove the housing below the spray arm and see if anything has lodge in the in impeller. Please let me know if I can assist you further.

Vic
6/12/2009 11:40:35 PM • Roper 24 in.... • Answered on Jun 12, 2009
0helpful
1answer

Jenn air dishwasher- making loud noise in operating cycle

Hi I am Vortash by the sound of what you are descibing your pump bearings seem to be shot , although it is making this sound is it still washing properly if so it confirms it is the bearing and not the impeller catching and making the noise the pump gets to quite a high pressure to wash the dishes .. sort of an enclosed hot jet wash the force of which drives the spray arms .. so I am afraid it looks like you will soon need a replacement pump.. sorry to bare bad news .. Regards Vortash
5/22/2009 12:26:33 AM • Roper 24 in.... • Answered on May 22, 2009
Not finding what you are looking for?
Dishwashers Logo

Popular Tags

35 questions posted

Ask a Question

Usually answered in minutes!

Top Roper Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

mark warfield
mark warfield

Level 3 Expert

453 Answers

Brad Brown

Level 3 Expert

19166 Answers

Are you a Roper Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Roper Dishwashers

  • Roper Dishwashers

Most Popular Question

dishwasher detergent dispenser not

  • Dishwashers
Loading...