20 Most Recent Kenmore HE2 Plus 3.6 cu. ft. Super Capacity Front Load Washer - Page 5 Questions & Answers

0helpful
1answer

Water begins to fill then stops followed by ticking sounds, was working for the last 3 years!

Relays on the ECU are failed. You must replace the ECU to solve.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.
12/6/2022 12:59:09 AM • Kenmore Washing... • Answered on Dec 06, 2022
0helpful
1answer

My Kenmore elite quietpak9 HE4 MOD 110.85866400 WONT POWER ON ,THE "CONTROL LOCKED" INDICATOR LIGHT IS LIT , I tried pressing the button for 3 seconds to unlock it but it won't unlock at all

Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the dryer (usually 5-7 minutes, and then power it up again.
12/1/2022 4:13:02 PM • Kenmore Washing... • Answered on Dec 01, 2022
0helpful
1answer

Kenmore HE2 Plus 110.4751 Series. I saw the answer for is there a ball in the drain hose for my HE2 Plus washer.

Question edited for clarity, full make and model. Question moved to Kenmore. Help in the link. https://www.google.com/search?q=kenmore+he2+plus+washer+drain+hose+ball+valve ..
12/1/2022 6:00:48 AM • Kenmore Washing... • Answered on Dec 01, 2022
0helpful
1answer

Kenmore front load washer rocks when spinning and cant seem to get it level so that it doesnt rock side to side

By 'side to side' I'm assuming you mean it's rocking left to right and not front to back? The most common direction it will rock will be on a diagonal line. How far is it rocking? A small amount or a large amount? Small amounts can be adjusted. If it has recently started rocking badly, especially on high spin, it might suggest there is another issue that needs looking at. Most machines only have adjusters on the front. Wind both feet all the way In then wind them both Out again 5 full turns. You might need a helper for this as you will need to tilt the machine to take the weight off the feet. Physically push and pull the machine to see which direction it is rocking. It will always rock on the highest points. On the corner that lifts wind that foot Out half a turn and the other foot In half a turn. Repeat this using Half or Quarter turns until the machine levels out. If the rocking direction changes sides wind the foot you have just wound Out back In the half/ quarter turn you have just used but Not the other foot. You might need to 'fine tune' with more eighth and quarter turns over the next few times you use the machine. At this point you only need to adjust the foot that actually lifts off the floor. If it rocks evenly down the centre line of the machine it might be the actual floor causing the issue.
11/27/2022 8:53:22 AM • Kenmore Washing... • Answered on Nov 27, 2022
0helpful
1answer

Kenmore 20 Porcelain Plus Refrigerator. Model number 8740911 makes banging noise when the cooling cycle ends. Quite loud. Refrigerator works fine. Any ideas?

Make sure the fridge is level back to front and left to right. Banging is normally the compressor shuddering on its rubber mounts, or the compressor is failing. Watch the unit from the rear as it shuts off. You may need to remove a cover held by a couple of screws. https://www.google.com/search?q=Kenmore+20+porcelain+plus+banging ..
11/25/2022 8:07:05 PM • Kenmore Washing... • Answered on Nov 25, 2022
0helpful
3answers

How can I soak clothes in a Kenmore washer without the water draining out

Fill it and disconnect it from mains power. When you reconnect the power, it will drain out. Then select another program. or You pick the longest program with pre-wash. Some models have a pre-wash program where you press a button to make it continue after soak and tumble.
11/25/2022 4:53:14 AM • Kenmore Washing... • Answered on Nov 25, 2022
0helpful
1answer

Kenmore front load washer leaking.

Replace the water inlet valve, it is sticking open a bit. FULL make and model in all questions please.
11/23/2022 1:49:21 AM • Kenmore Washing... • Answered on Nov 23, 2022
0helpful
1answer

Kenmore Elite Smartwash 9 Front Loader won't drain or spin. I've followed all of the troubleshooting in the manual; nothing works. HELP!

In that case it is likely to be a control board issue, and for that you need a service call to get the correct diagnosis and warranty on the part and the repair. Usually a power reset will fix most control board issues.
11/20/2022 11:07:20 PM • Kenmore Washing... • Answered on Nov 20, 2022
0helpful
2answers

My Kenmore series 80 washing machine will not automatically do the drain, rinse & spin cycle.

Hi, please rotate your cycle dial in the opposite direction of its usual motion by 90 degrees (probably counter clockwise). Then you can run the cycle again and the drain/spin/rinse should work. Otherwise, please power cycle your washing machine. Thank you.
11/19/2022 4:38:27 PM • Kenmore Washing... • Answered on Nov 19, 2022
0helpful
1answer

KENMORE WASHER 110 27802690 NO HOT WATER?

This has probably already been done, but often debris from the hot water line will plug the screen that is at the inlet. this is often a rubber washer with a screen molded into it. scale from water heater and lines builds up and cuts flow way down this video gives an example. https://www.youtube.com/watch?v=xED_4n5e_ww
11/18/2022 6:37:13 PM • Kenmore Washing... • Answered on Nov 18, 2022
0helpful
5answers

My Kenmore serial #CX4205509 washing machine stopped working

Press the stop button about twice and then next press the power button.Pick a washing cycle and choose a washing option and then press the start button to finish the reset process and restart your washing machine. If your washing machine still is not working it might be time to call a repair person to take a look and see what the problem is.
11/17/2022 1:09:02 PM • Kenmore Washing... • Answered on Nov 17, 2022
0helpful
2answers

How to replace control board on a Kenmore Oasis Elite washer

Hi, you would need to setup an in-home service with kenmore of home depot as dealing with the internal components of an electrical product could be a fi re hazard. Thank you.
11/17/2022 4:11:15 AM • Kenmore Washing... • Answered on Nov 17, 2022
0helpful
1answer

When was my Kenmore electric dryer made?

Replace the belt.
11/8/2022 11:58:19 PM • Kenmore Washing... • Answered on Nov 08, 2022
0helpful
1answer

Need help identifying mystery washing machine part

Photos of part: img1-oibkqqin10hmcnhnss5n2t1z-d-0.jpg

img2-oibkqqin10hmcnhnss5n2t1z-d-2_0.jpg
11/3/2022 1:51:02 PM • Kenmore Washing... • Answered on Nov 03, 2022
Not finding what you are looking for?
Kenmore HE2 Plus 3.6 cu. ft. Super Capacity Front Load Washer Logo

Popular Tags

16 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

vince

Level 3 Expert

1528 Answers

Marvin
Marvin

Level 3 Expert

85241 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

HE2 Kenmore

  • HE2 Kenmore

Most Popular Question

kenmore front loader washer powers but

  • Washing Machines
Loading...