20 Most Recent
Mitsubishi MSZ-GE24NA Mr. Slim Wall Mounted Indoor Unit Air Handler - Page 8 Questions & Answers
My Eden pure model Gen 3 doesn't turn on ? The red light on front is lite and filter is clean Why not
Edenpure has a troubleshooting guide at this website:
MY HEATER WILL NOT TURN ON.
- Make sure the power source is good. Plug in a lamp to see if it works correctly.
- Make sure the front power switch/button is set to the "ON" position.
- Unplug the power for 30 minutes. Plug the power back in and try operating the heater again. This will reset the internal sensors.
- Some heater models are designed to be operated in temperatures less than 75 degrees Fahrenheit. The heater will not operate when the temperature is too high. Test the heater in a room that is below 75 degrees Fahrenheit.
- Bring the heater inside to warm up for at least one hour before operating if it has been stored in a freezing or near freezing environment.
- Make sure the filter is clean.
- Remember, it will take a few minutes for the heater to warm up. The fan will start to blow after the heater has warmed up.
Heaters FAQ
On/off switch stuck Brookstone air filter 561274, can't open top to get to switch
there are two very small screws just above the on/off switch. Once you unscrew those two, you can use a knife (carefully) to lift the on/off panel out of the air filter. I just did this. My problem is now that I don't understand how the on/off button is supposed to work at all.. there was no spring or anything I can see that could have pushed the on/off button back up. I am considering just leaving the actual button out and pushing the microswitch directly. Looks like bad engineering to me.
Not finding what you are looking for?