Zanussi 24 in. DE6544 Built-in Dishwasher - Answered Questions & Fixed issues

The dish washer control panel is defective most likely, have it diagnosed.

Try cleaning all the jet orifices in the rotating vanes. Use tooth brush. Check for dish plate is touching the rotating arm in the wash chamber. Rotate by hand for freeness.

pull the unit out and tilt backwards should be able to get to it from underneath

Hi there,

Well first of all you can check the Water-inlet valve
Most cleaning problems are caused by the dishwasher not getting enough wash water, so the water-inlet valve is often to blame. This valve is usually at the bottom left or right of the dishwasher, behind the lower access panel. It's the device with the main water line from the house, a rubber tube to the dishwasher, and two wires attached to it. When a water-inlet valve is defective, you may hear the sound that's usually referred to as "water hammer." If the water-inlet valve is defective, you need replace it.
After then you can check the Drain valve,  that should open only during draining. If debris lodges in the valve, it can't close properly, so water drains out during the wash cycle. Most dishwashers drain into the garbage disposer. If yours does that, listen for water flowing into the disposer during the wash cycle. If you can hear it then, the drain valve may be clogged.
Please post comments if you need more help or information..............

Good Luck!!

Thanks

Zanussi Aquapulse dishwasher - is filled with water inside, is not washing and the lights keep flashing on and off - has anyone any idea what may be wrong with it?

Solve at the end of each cycle there is a puddle of water at the bottom, it doesnt sound like its pumping... (More)

I think that the problem is the water inlet valve if the machine is not filling at all.

If the machine is not filling to the correct level, it may be the float switch.

WHAT IS THE EXACT BRAND/MODEL AND NUMBER OF YOUR APPLIANCE...?

DID YOU TRY TO RESET THE UNIT, BY UNPLUGGING IT FOR A WHILE INTO THE POWER OUTLET...?

REPLACE THE WASHERS TIMER

I WOULD REPLACE SOLENOID AND TIMER

the water-inlet solenoid valve is inoperative-replace it

exercise to lose belly fat; fat loss extreme; workouts to lose belly fat; best foods to eat to lose weight; diet for weight loss for female; dr now diet plan; simple 1200 calorie meal plan; meal plan for weight loss and muscle gain female; 1200 calorie a day meal plan; lifting weights to lose weight; foods to eat to lose weight; lunch for weight loss; healthy lunch for weight loss; healthy foods high in fat; https://behealthyideas.com/ <ahref="https://behealthyideas.com/">https://behealthyideas.com/</a>

If it is new, it is under warranty and if you try to fix it, it will void the warranty. The water in the flood tray comes from the machine itself, normally from hoses or on an older machine pump seals. Page 17 refers and confirms https://manualzz.com/doc/53457617/zanussi-zdln1512-user-manual Call for warranty service to fix the fault free of charge.

input to pump clogged output clogged pump bad or just dirty inside. leaks end to end that path, In and output.

Under the base of the machine, above the floor there is a tray with a sensor in it and that is what triggers the Flood Error Code. So the machine needs to come out, the back or side panel removed and the tray thoroughly dried. You also need to find where that water came from. If the salt container is in the base, it may be leaking if you were breaking up the salt.

get a tech out there, as these appliances get more sophicated, they become nightmares its best to buy a basic model

There is no external adjustment in a dishwasher.

Bad timer zz

It is normal that after adding the salt it takes time to dissolve, which means that the salt lamp will be extinguished after several complete washing cycles. Dado