20 Most Recent Zanussi 24 in. DE6850 Free-standing Dishwasher Questions & Answers

0answers
0helpful
1answer

Where is the thermostat on a zanussi dishwasher

Thermostat should be in the base of the dishwasher next to the heater element and looks like this part. http://www.espares.co.uk/product/es567728/dishwasher-temperature-sensor?PartTypeId=1532&ModelId=576996
4/19/2014 12:25:51 PM • Zanussi 24 in.... • Answered on Apr 19, 2014
0answers
0helpful
1answer

Westinghouse SB907SJ dishwasher not heating

replace the heating rod that surrounds the pump base drain
11/18/2013 7:44:36 AM • Zanussi 24 in.... • Answered on Nov 18, 2013
0helpful
1answer

How to replace heating elemant on Zanussi DE6850 Dishwasher

is your water heater set on 120 degres
6/19/2013 11:12:01 AM • Zanussi 24 in.... • Answered on Jun 19, 2013
0helpful
3answers

ZANUSSI DE6855 DISHWASHER - NO HEAT FOR WASHING OR DRYING

Make sure you unplug before you start. I had the same problem with a DE6850. The heater was ok. Metered at 25.ohms. Apparently, the relay on the control board mounted in the front door behind the switches is a common fault. Remove the screws around the top part of the door and you will be able to get at the control module. Resolder the connection. Zanussi reliability has been lost. Noel P31bf5e2.jpg
3/1/2012 12:36:04 AM • Zanussi 24 in.... • Answered on Mar 01, 2012
0helpful
1answer

My zanussi dishwasher DE6854 doesnt seem to be

Hi, I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher SprayArms not Spinning

How to Buy ApplianceParts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The HeatingElement not Working

DishwasherMaintenance DishwasherResidue and Film on Dishes

heatman101

Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes

;; ' '
;
6/12/2011 2:52:54 AM • Zanussi 24 in.... • Answered on Jun 12, 2011
0helpful
1answer

Where is the heating element on a zanussi de6850

remove RHS panel and you will see it bottom right. looks like a round cylinder with wires going into it.

if not heating worth looking at main board as wel for a broken solder joint on heater relay. bit of solder will sort this
10/19/2010 10:49:08 PM • Zanussi 24 in.... • Answered on Oct 19, 2010
0helpful
1answer

DE 6850 not drying

Hi,
Check your heating element..
A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

heatman101

Asker's Testimonial " explanation very clear. will give it a go and seehow simple it was. thanks Ronnie " - ronnieshomes
9/18/2010 4:37:33 AM • Zanussi 24 in.... • Answered on Sep 18, 2010
0helpful
1answer

Zanussi de 6850

I've just had similar - seems to be a problem in the controller module - they're reasonably inexpensive online.
Undo the top-part of the door, about 5 screws across the top and side - the top section pops out, and the control module is now on the inside - if you free off the connectors (not too simple, but doable) you'll probably find some scorch marks on the PCB ... hopefully the wiring isn't damaged, and you can just replace the PCB ...
If you also have wiring damage, well, trace back and replace as required
(probably too late for the OP, but worth recording in any case)
8/28/2010 9:00:58 PM • Zanussi 24 in.... • Answered on Aug 28, 2010
0helpful
1answer

Zanussi DE6850 doesn't start. switches on and then not a sound?

Hi


Thanks for using FixYa. You’ll need to check the following things--

1. Fuse (blown or tripped).
2. Check the wire fasteners at dishwasher junction box.
3. Electronic control board.
4. Motor (inoperative, check resistances).
5. Door switch (open contacts).
6. Door latch not making contact with door switch.
7. Touch pad circuit defective.
8. No indicator lamps illuminate when START or OPTIONS is depressed.

Please do accept the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee
7/20/2010 3:02:26 PM • Zanussi 24 in.... • Answered on Jul 20, 2010
Not finding what you are looking for?
Zanussi 24 in. DE6850 Free-standing Dishwasher Logo

54 questions posted

Ask a Question

Usually answered in minutes!

Top Zanussi Dishwashers Experts

Paul Carew

Level 3 Expert

3725 Answers

Geoffrey White
Geoffrey White

Level 3 Expert

3965 Answers

Marvin
Marvin

Level 3 Expert

85240 Answers

Are you a Zanussi Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Zanussi Dishwashers

  • Zanussi Dishwashers

Most Popular Question

heating element zanussi de6850

  • Dishwashers
Loading...