20 Most Recent Zanussi WJS1397W Front Load Washer / Dryer - Page 9 Questions & Answers

Lay down the washing machine and on the underside (bottom) you can access to a filter and small drainage hose. End of drainage hose connect to filter housing Dado

Spin With this option you can change the default spin speed. The indicator of the set speed comes on. Additional spin options: No Spin • Set this option to deactivate all spin phases. Only the drain phase is available. • The related indicator comes on. • Set this option for very delicate fabrics. • The rinses phase uses more water for some washing programmes. Rinse Hold • Set this option to prevent the laundry creases. • The related indicator comes on. • There is a water in the drum when the programme is completed. • The drum turns regularly to prevent the laundry creases. • The door stays locked. You must drain the water to unlock the door. Dado

First: make rapid reading of alarms How: the appliance is in normal operating mode (e.g. while the washing programme is in operation) than: Press START/PAUSE and any one of the option buttons simultaneously for at least two seconds: the LEDs first switch off, and then display the flashing sequence corresponding to the alarm condition. The alarm is displayed by a repeated flashing sequence of the two LEDs: 1. END OF CYCLE indicator = indicates the first digit of the alarm code (family) 2. START/PAUSE ? indicates the second digit of the alarm code (number within the family). After reading alarm code look down= Could be: E33 - Incongruence between contact closure of antiboiling and 1st level of pressure switch. Remedy: Pressure switch faulty; Current leakage from heating element to ground; Heating element; Wiring faulty; Circuit board faulty. E35 - Water overflow. Remedy: Water fill solenoid faulty; Leaks from pressure switch hydraulic circuit; Pressure switch faulty; Wiring faulty;Circuit board faulty E36 , E37, E39 - Circuit board faulty Dado

Might be a loose wire on the rotating program switch or a faulty switch.

Pull the hose off the back of the drain pump, there might be something caught in the filter housing

I would check the brushes on the motor. If these are worn that can stop the machine working full spin under load

The catch is broken that locks the door

Hello,

Check the heathing elements.

I think you may find a button or other debris in the pump housing preventing the pump from emptying all the used water eric

go to the manufactures website and download the user manual its normally free eric

my best advice is to call the engineer or go on line to the manufactures website and request if there is a solution as force is not the answerer eric

Remove the complete agitator. Unscrew the top of the agitator and you will get to the screw that holds the entire module. You will need an extension bar to get to the screw with a ratchet set. The head should be 5/16" and then you can get to the item.

E59 is shown in the service manual to be a defective motor and can be a defective inverter board too.