I haven't worked on a Zanussi yet but usually once the top has been removed replacing the belt is a fairly straightforward and intuitive process - it is removing the top that tends to be the difficult part.
I expect washer-driers would be more difficult but so far I have managed to avoid those.
Incongruence between level of electronic
pressure switch and level of anti-boiling
pressure switch 2 (duration of fault at least 60
seconds).
Cycle is blocked with door closed.
Could be: Hydraulic circuit of pressure switches; electronic
pressure switch; pressure switch; wiring between main PCB and electronic pressure switch; wiring between main PCB and safety pressure switch; and finally main PCB.
Dado
You may have accidentally activated the child lock. There's usually two buttons on the control panel which have a very small picture of a lock underneath them. Hold them both in simultaneously and the lock will be deactivated.
This is probably the child safety lock. There should be two buttons on the control panel which should be pressed simultaneously and held in. This will deactivate the lock. The buttons have a tiny picture of a lock underneath them.
You have to take it apart. Its from 2 parts. Screw up screw in top, in sides at bottom ant in back at bottom.Carefully take out plastic with water inlet valve.
Step 3:
Now you have to see shock absorbers. They are fitted with plastic sticks.On them is small fixation - push it down and pull it out with pliers.Ask if manual needed.
Count how many times the red light flashes and how many the green light flashes.If its 1 green and 1 red thats water problems.If 2 flashes of red light check filter is clear and pump is free to turn.
It is a common fault that the drain fails to work in most machines in a period of time and is the most problematic fault in a washing machine. In all occasions it is important that your observation is most important and so is vital to the identification /rectification and solution. If you have noticed that water has leaked then as the drain hose pump/valve and fittings are located on the underside of the machine it is important that you look for possible leaks here. In some cases the drain hose would be clogged at the drain end to outlet of the house and so there will be back flushing resulting in overflow to the outside. Also the drain pump/valve can be clogged. Now remove the drain hose clamps and remove the drain pump/valve, clean the drain pump/valve, use back flushing to clear off all dirt. Now test using power to see if this works and can be simulated. When refitting, the hose must be tightened properly. If the pump/valve does not work even with power then it must be replaced.If there is intermittent power to the drain valve/pump then the program controller unit is a suspect.
Finally the washer must be placed with a tilt- use a spirit level- so that all water will drain to the outlet port and thereby there is no residual water remaining.
Replacing the pump on a Bosch machine, please check this link for tips:
Hi thereTry opening the dispenser fully, put your better hand inside and feel for a knob that you can push, and the dispenser comes out..The knob can also be on the bottom of the dispenser.If you do not find those knobs, just take a brush for washing up and some warm water in a bowl and clean the dispencer the old fashioned way.Good luckKolbrun