20 Most Recent Zanussi FC1200W Front Load Washer - Page 9 Questions & Answers

Might be a loose wire on the rotating program switch or a faulty switch.

Pull the hose off the back of the drain pump, there might be something caught in the filter housing

I would check the brushes on the motor. If these are worn that can stop the machine working full spin under load

The catch is broken that locks the door

Hello,

Check the heathing elements.

I think you may find a button or other debris in the pump housing preventing the pump from emptying all the used water eric

go to the manufactures website and download the user manual its normally free eric

my best advice is to call the engineer or go on line to the manufactures website and request if there is a solution as force is not the answerer eric

Remove the complete agitator. Unscrew the top of the agitator and you will get to the screw that holds the entire module. You will need an extension bar to get to the screw with a ratchet set. The head should be 5/16" and then you can get to the item.

E59 is shown in the service manual to be a defective motor and can be a defective inverter board too.

You should be able to get one from zanussi by going on to there website