Top 20
Canon iRC3100 Printer Questions & Answers
E000012-0001
Thread irc 3220 error e000012 0001
Your ITB unit (Intermediate Transfer Belt) may need changed. Try removing it first and rotating by hand.
If it sticks, you are probably looking at a new unit.
The link above is for the iRC3220 but Canon codes are generally all the same.
You may find there's a tear in the belt and this is why it is not working properly.
Error e602-0003
This is Hard disc error, before changing the hard disc ,first try to format it and re install new firmware by using service support tool, if you are not able to do it change the Hard disc, your problem will be solved.
E000020 0081
E000020 0081Related to Control of Toner Concentration
Error code e0000260401 please tell me what for
Toner empty errorXX=01:Y XX=02:M XX=03:C XX=04:Kxx01:After toner runs out, toner density fails to go back to normal even if toner replacement and toner recovery have been performed 5 times or more in succession.Replace the toner container, Check on a position of the developing shutter
Error code e000070 0003
Hello E007 cannot be cleared in service mode.
Ensure the ground spring (FC5-0516-000)
is not bent and grounding the registration hard roller (FL2-0104-000) properly. It may be necessary to clean the grease to insure a good ground path. Straighten the ground if BENT. Clean surface to ensure proper grounding.
if you need more help a service manual is always good to have you can donload it from the below link:http://goo.gl/dqR2Vggood luck
Its coming up "paper jam" but there is no jam in
It seems like your printer might need internal service. You can use some alcohol swab to clean the inner rollers to function properly. If the problem still persist then you can either take it to some hardware shop and ask them to do a through clean up for you.
E000021-0001 error code
The Canon Color Image RUNNER 3200 machine has two on and off switches. Facing your machine. One is on the right side and the other is on the back left side. Shut machine down. Wait for about 10 min.s turn switch on.
Printer install
Make sure installation was done correctly and go to print screen and see what printers are on it and make sure the one your trying to use has a check mark or other identifying mark saying this is painrinter that is to be used. If you have to uninstall and redo again.
E00748-4000 error on canon irc3180 copier
Try this Board Cleaning & re-Positioning Procedure
Works 98% of the time for this e748-4000
your model is in same family as those listed in pub
or----------------------
Check or swap or replace the DDI-S Serial Cable before replacing any boards.
If the cable is poorly connected or otherwise defective an error code of E748-4000 may be the result.
Not finding what you are looking for?