20 Most Recent
Canon imageCLASS D880 All-In-One Laser Printer - Page 2 Questions & Answers
Error e000
install the printer drivers first restart your computer then plug the usb into the printer for the "first time' you might plug it into the usb ports at the back of your computerhope this helps you
Canon imageCLASS D861 - Windows
Hello,
Unfortunetaly, there is no solution for your problem, Canon did not made drivers for 64-bit OS's.
AlterantivelyYou can try download
Windows XP mod for WIndows 7 or any other virtualization software, and try to install drivers on the virtual PC.
This should work for you.
Canon D880 Printer/Fax
1. Take off 3 plastic covers one above exit area-slide top to left to access screw
remove lower exit cover and side cover -unsnaps with 2 pins and there is one more cover I think over the fan that needs to come off.
2.Locate black plastic sheet covering a circuit board carefully pull this back-disconnect 3 plastic connectors that lead from the heater to the circuit board
3. using a offset phillips #2 screwdriver remove 3 screws that hold the fuser to the frame. carefully lift fuser up and out toward the exit area.
4. pop off black cover remove 2 screws from top of fuser, disengage cover lid locks with a small screwdriver, lift upper fuser heater-be careful NOT to damage
plastic heater membrane. remove paper jam and reassemble.
Took out all possible paper, but keeps saying
This error message is displayed by the printer when paper is jammed in one or more locations. In such a case, users are recommended to remove the jammed paper from the specified location. The entire paper path must be checked for any pieces of paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor or sensor lever.
WHERE TO FIND A SERVICE MANUAL FOR
http://www.generalmanual.com/Printers/Canon-imageCLASS-D860-D880-Personal-Digital-Copier-Printer.htm
this is the link for your manual please rate my assistance
I have got a CANON
hi, i am glad to see you have done the normal checks with the volt meter, but there is an internal fuse for these, you will have to gain access to the power supply inside, on or around the power supply should be either a 3 or 5 amp clear fuse, these are not your normal type fuses like you get in the plug, but these are slightly longer and clear glass........do not except this answer yet please, no thumbs up till you fix the problem, then can you thumbs up and accept the answer thanks...............
Not finding what you are looking for?