4 You can remove the pads and the holder with a gentle pull.
5 Using a tissue, soak up as much ink as possible and clean the area around the waste
ink area.
6 There is one more waste holder in the right back bottom of the printer. A kind of
sponge. There are few screws and plastic parts to be removed and this sponge needs to be
washed, dried and placed again. Be careful and patient. This is no understatement. On the
iP1500 this requires the dismantling of most of the printer. Take a photograph (even with your
cell phone) so you can trace back your steps. On the iP1500 the drive motor on the side (Just
behind the waste ink pads) has to be removed to get to the main sponge. You also need to
take care as you lift the slide/carriage. Below this you find 5 little springs.
7 Carefully replace the holder and the pads. Close printer.
8 Whilst printer is disconnected from the mains power, press and hold the power button
and reconnect to ac power.
9 Release the power button.
10 Press the power button again.
Thank
312 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions