20 Most Recent
Canon DR-7080C Flatbed Scanner Questions & Answers
Hi. I am looking
I have many years of repairing Canon scanners and here is my suggestion to you.
You can also get them on the US site also, I will include the link for the drivers in this response. The problem your going to have is that to upgrade your firmware you need a piece of software to upgrade the firmware on your scanner. That piece of software is only released to canon dealers and its also used for diagnostic's of your scanner and to make adjustments to your scanner. I would contact your local Canon dealer, and ask what they would charge you if they came out to do this service for you, or what would they charge you if you brought the scanner to them to cut down on the cost of this very simple update. It only takes a couple of minutes to upgrade your firmware on your scanner. Below is the link to Canon's website for the files you need. I hope this helps you out.
http://www.usa.canon.com/cusa/support/office/imageformula_scanners/imageformula_dr_7080c/imageformula_dr_7080c_color_production_scanner#DriversAndSoftware
I have a Canon DR-7080c.
I
If the 'noise' is in the same place with varying intensity it is definitely dirt on the glass. Clean with Isopropyl alcohol (rubbing Alcohol). Dont use any solvent.
S. Mohan
Fix scanner dr 7080c
We had the same problem and called a Canon technican to come out.
Open the lid, take the two screws on the left-hand side out, so you can remove the flatbed glass.
You will have to remove one or two metal plates to get the glass out. Be very careful with the glass!
Now you can get to the mirror part. You should be able to put it back into place.
Hopefully this helps!
Trouble with paper feed
Frequent jams are because either scanner picks up more than one paper or does not pickup at all. If scanner picks up more than one paper, then paper is sticky. If the paper is thin, it can pick up two at a time. Fan the papers so that they are not sticky.
Paper at the point of entry into the scanner must be crisp. If folded or 'dog-eared' trim it. Rotate the paper if any other side is crisp, roate the image later.
Clean all the rollers thoroughly, the pickup roller, retard roller and other rollers in the scanner. One can rotate the inner rollers and clean totally, not just waht is seeable area. If the rubber is worn out, it must be replaced. TRy a single page to check if the rubber is okay. Jarring noise is because the motor is 'stopped' and cant rotate because paper is stuck. This can affect motor/inner parts, but is designed for normal use.
UNABLE TO STOP SCAN FROM PC
Try reinstalling scanning software. If one of the DLL files are corrupted, this can happen. Also run Scandisk of your hard drive.
S. Mohan, Chennai, India
Scanner issue
please clean the glass with wet tissue paper and see.
bye
Not finding what you are looking for?