It might be one of the following: 1. Voltage changeover selector switch has blown - check if the power is still there before it enters the switch and still there after it leaves. 2. Breaker has failed on that leg - test before and after to see if working correctly 3. The plug socket has failed - Look for burn marks where wiring enters. 3. There is a fault in the alternator - see 2nd video down on this page for testing:https://www.generatorguru.com/help-me-fix-my-generator-repair-advice/ Hope this helps you. If you need more advise please contact us on our website www.generatorguru.com. We are always happy to help.
Kind regards The Generator Guru Team www.GeneratorGuru.com gg_pic5black_adwords_1200x1200small-u42hrofub43isob1vkbjdq4v-5-14.jpg

gg_pic5black_adwords_1200x1200small-u42hrofub43isob1vkbjdq4v-5-14.jpg

Generator Guru

Dewalt... | Answered on Oct 29, 2018

2 Answers

I just bought a Dewalt thickness planer and it keeps blowing out my circuit breaker,....which normally works fine and is 15 amps, which matches the rating for the planer. Can this be fixed?

It should be used on a 20 amp circuit. the 15 amp is the maximum your circuit will deliver. on startup it may exceed the limit. also your circuit may or may not deliver the power for a sustained time. do not use extension cord small than 12 gauge

Dewalt... | Answered on Aug 06, 2018

1 Answer

How do I find the serial number on my Dewalt 1800-watt portable power station for future warrenty and repairs?

https://www.dewalt.com/en-us/support?productsku=DCB1800B

Dewalt... | Answered on Aug 03, 2018

1 Answer

I need to rewire my dewalt DG2900 generator to the plugs

Choose your brand

Dewalt... | Answered on Feb 26, 2018

2 Answers

How do I unseiz my dewalt DG6000 generator motor due to non use

Remove spark plug. Pour a small amount of a lubricant like Marvel Mystery Oil in and allow to soak for a day or two. Repeat this process at least two times. Then try to turn the engine over slowly by hand. Do not use the pull rope or starter. You need to use a wrench, pry bar, etc. You may have to remove the engines cover to access the flywheel to turn it.

Dewalt... | Answered on Oct 07, 2016

0 Answers

I want to register DW325Pl nailer

Dewalt... | Posted on Mar 06, 2016 | Be the first to answer

2 Answers

Will only run for 10- 15 min. then shuts off.

You might have a thermal issue with the ignition coil shutting down after it gets warm. Happens.

Dewalt... | Answered on Sep 25, 2015

1 Answer

Gas in oil on dewalt generator

It's your carburetor. You'll have to clean it out, rebuild it, or buy a new one. The float pin is getting stuck so it's either the float or dirt inside. Make sure you turn the gas off after each use of your generator or it will eventually happen if there's dirt in the tank. Don't forget to change out the oil before you start it again or you'll have fireworks.

Dewalt... | Answered on May 28, 2015

1 Answer