20 Most Recent Zanussi ZHF470 Electric Double Oven Questions & Answers


Called Engineer in the end, Heating element needed replacing

Zanussi ZHF470... • Answered on Mar 05, 2014


You need to replace the oven element, located behind a removeable panel at the rear of the oven compartment.

Zanussi ZHF470... • Answered on Aug 07, 2010


Probably oven element has failed, a common fault.
It is located at rear of oven behind a removeable cover.

Zanussi ZHF470... • Answered on Feb 22, 2010


no but if u call zanussi customer care they will send u an instruction booklett number is 08705727727 op 3 hold op 2 op 2

Zanussi ZHF470... • Answered on Nov 19, 2007


Hi
I must see a picture of it.
Sometimes the leavers are jump out but you can get them inside and to close the door.try it or send apicture.

Zanussi Ovens • Answered on Mar 07, 2019


It sounds like your main board or some wiring was damaged due to heat during the self clean process. The board will need to be accessed and tested.

Zanussi Ovens • Answered on Feb 11, 2019


H there try this... Deactivate the oven with the house fuse or the safety switch in the fuse box and activate it again. If the above advice does not resolve the problem, we recommend requesting a visit by a repair technician or check out your other option with an expert https://www.6ya.com/mr.mike Good luck and thank you Mr.Mike

Zanussi Ovens • Answered on Jan 31, 2019


The problem is most likely with the Large Rectangle Grey X2 Capacitor on the clock circuit board which needs to be replaced by an appliance repair person or electrician. From my understanding, although they are self-healing, as they are subjected to power surges they deteriorate and allow less and less current through the circuit until they get to a point where there isn't enough current flowing to firmly latch the relay (which is why there is a buzzing from the relay turning on and off quickly). My clock was also at the point where there wasn't enough power for the timer beeper, so when the beeper went off it would reset the clock after about half a beep. And if the clock was started at 12:00, when it got to 16:08 it would reset as there wasn't enough power to display all those led segments. I replaced the 1000uF capacitor, which didn't change anything, then replaced the X2 capacitor and now it works perfectly! Hopefully that is helpful to someone. :)

Zanussi Ovens • Answered on Jan 14, 2019


Check wiring for direct short.

Zanussi Ovens • Answered on Dec 13, 2018

Not finding what you are looking for?
Zanussi ZHF470 Electric Double Oven Logo

Popular Tags

11 questions posted

Ask a Question

Usually answered in minutes!

Top Zanussi Ovens Experts

Cindy Wells

Level 3 Expert

6253 Answers

Paul Carew

Level 3 Expert

3538 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Are you a Zanussi Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Zanussi Ovens

  • Zanussi Ovens

Most Popular Question

bottom oven dosent heat

  • Ovens
Loading...