American Standard 7881.732.099 Hampton Widespread Bathroom Faucet 7881.732.099. Bathroom Faucets polished brass. In polished chrome 7881.732.002, satin nickel 7881.732.295. Hampton Widespread Lavatory Faucet 7881.732.099. Brass Crescent spout. Metal Lever Handles. Met - Answered Questions & Fixed issues


Depends how old your toilet is, it may be a calcium build up problem on your little inlet pipe inside your tank, but first check your water shut off valve on left side of your toilet near the wall....It may not be open all the way OR the valve has an issue...

American... | Answered on Jul 12, 2019 | 136 views


Hey, One thing is that maybe there might be some loose plastic shavings in the fill line. From the Factory? or maybe was inside the water line going to the toilet when you connected the line to toilet. Shut off the water and get some towels and something to catch the water and disconnect it from the toilet and use bowl or what ever to catch the water and slowly turn it on and see if anything comes out. Maybe if it is in the line inside the toilet it might fall out by lightly tapping on the fill line inside the toilet to help it fall out. Just a thought when you said it "Sings" that sounds like trash inside the line going to the filler tube and bowl, hey try it who knows it might work. Okay

American... | Answered on Jul 12, 2019 | 167 views


Hi,

First, carefully remove your tank lid, and place it where it won't break or fall. Look for a four-digit number located on the back of the tank, near the water level mark. This is your tank model number. If the number starts with a two, it is a one-piece toilet.

Then....visit this link:
https://www.americanstandard-us.com/parts-support/faqs/toilets

Good Luck!

American... | Answered on May 06, 2019 | 142 views


More likely the sensor has malfunctioned.

American... | Answered on Nov 24, 2018 | 104 views


these are called phantom flushes. the water is slowly leaking around flapper or the is a scratch of the flapper seat. I use fluidmaster parts

American... | Answered on Nov 12, 2018 | 329 views


Toilets wear out from mineral deposits. Fixn may cost more then new. Googl used commodes first

American... | Answered on Nov 04, 2018 | 208 views


Water turned off or fill valve bad.

American... | Answered on Aug 29, 2018 | 144 views


I think it's not a wise decision to clean a toilet fill valve, rather than buy a new toilet fill valve and replace with the old one.

Thanks.

American... | Answered on Jun 08, 2018 | 1,857 views


Yes you can replace the handles as they are available from American Standard, directly. Go to their web site, parts and service, and select you mod. toilet. Order from them. https://www.americanstandard us.com/bathroom/toilets-category

American... | Answered on Feb 05, 2018 | 194 views


First, make sure the water feed to the tank is wide open, then make sure you have the inner workings set at maximum water level.

American... | Answered on Feb 01, 2018 | 54 views


Hey. Not sure what model you have, but I assume you're trying to light the pilot. Remove the metal outer and inner (if applicable) cover(s) located at the bottom below the control box. with a flashlight, you should be able to locate the "thermocoupler" -that's a very thin metal tube about the thickness of cooked spaghetti. It should come from the controller and bend around a little until it ends in mid-air. That's where the pilot flame will first appear when you light it, and it should be always on, or else you will need to follow the instructions on the outside of the heater to do so. BTW: while the pilot should always be lit, the main flame (which heats the water) will only "fire" like a gas cooking range when the water in the tank starts to get cold - so don't expect to see any big flames any time you look. When you re-light the pilot, though, and turn the control dial to "hot", then you will both see and hear the flame fire up. Follow those lighting instructions VERY carefully, or the pilot won't stay lit (like, if it says to hold a button for 60 seconds, make sure you don't cheat). Good luck, hope I answered your question.

American... | Answered on Nov 28, 2017 | 33 views


Run a short snake thru the line. Somewhere between the drain and the tee into the line with the sink is a clog.

American... | Answered on Dec 16, 2016 | 2,809 views


Be sure to pull the plunger all the way up when diverting the water between the the tub and shower if ti keeps giving you a problem it's faulty

American... | Answered on Oct 19, 2016 | 355 views

Not finding what you are looking for?
American Standard 7881.732.099 Hampton Widespread Bathroom Faucet 7881.732.099. Bathroom Faucets polished brass. In polished chrome 7881.732.002, satin nickel 7881.732.295. Hampton Widespread Lavatory Faucet 7881.732.099. Brass Crescent spout. Metal Lever Handles. Met Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top American Standard Home Experts

Mike

Level 3 Expert

4369 Answers

john h

Level 3 Expert

23438 Answers

Bill Johnson

Level 2 Expert

306 Answers

Are you an American Standard Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...