20 Most Recent Kohler 30rz82 30kw Generator Power System Fast Response Nat Gas 890 Hours - Page 5 Questions & Answers

no a fuse is there to protect the circuit and the genset check why the de-icer is pulling so many amps as the problem may be in that unit a 10 amp outlet has a maximum current capacity of 10 amps as that is the current allowable from the gen set and wire capacity even if you had an outlet with 15 amp rating , it would still be blowing fuses as the 16 amps is above the allowable current draw you would need a 20 amp outlet ( difficult to get unless it is in a house power board and are normally reserved for hot water systems , stoves and other high current usage units and are normally then not outlets but hard wired in to a circuit breaker

change your air intake element and also clean your spark plug.

question to you are the rpms erratic under no load ( is the engine hunting on the governor) at what load setting does the problem start to occur

on the starter of the engine there are two teminals that should have 12volts to them while its cranking (or trying to) one has a 3/8 bolt stud and has a large wire/cable that should go to either the battery disconnect or direct to battery , the other one is 1/8" size and has a smaller wire to it , this is the trigger wire , it triggers the starter to operate , your going to need to look at those voltages when its trying to operate

yes ineed

3/4 Keyed Shaft ' eBay

www.ebay.com/bhp/3-4-keyed-shaft eBay3/4" Dia. Steel Shaft / Rod 18" Long. ( Keyed 3/16 "both ends ). $34.21 .... 3/4" to 1" inch w/Step Key Gas Engine pulley Crank Shaft Sleeve adapter Predator.

Vertical shaft Kohler Engines - Engine4Less.com

engine4less.com/ALL-Vertical-shaft-Kohler-Engines/ This engine has same mounting and shaft as all KOHLER Single cylinder ... 1"diameter x 3-5/32" length keyed VERTICAL (UP and DOWN ' ) crankshaft. Please ...

It is not a float issue because the motor cannot consume the entire contents of the gas chamber in one instance of a surge. This is a throttle issue.

How to test replace magneto

Here's a link to your manual. http://www.aaronequipment.com/equipmentattachments/46698001_kohler_30reozjb_spec_sheet.pdf

Compression Ratio: 9.0:1

http://www.bing.com/search?FORM=UP97DF&PC=UP97&q=How+to+remove+the+armature+from+a+engine+of+a+power+generator

what is the filter part number on the Generator now? Give that to an Auto parts place and they will cross it to what they sell

See if there is a heat shield for spark plug. Make sure proper plug is installed and gapped.

the compression ratio has nothing to do with head shape - it is the of the swept volume of the cylinder compared to one ( surface area X the stroke of the piston)

plugged fuel line or stuck float