20 Most Recent
Dell Precision M60 Notebook - Page 3 Questions & Answers
Can send music from precision m60 to phone via
You can find a bluetooth trigger button in your laptop it will be symboled like this ))).((( or else with your laptop kit they will be providing you a pen drive (bluetooth dongle)shaped device using that you can transfer the datas. or else you can install a bluetooth dongle device with your laptop to transfer datas.
No connection to the internet
if you have anti-virus/firewall, check the firewall if it is allowing your network to communicate with your laptop.
if you don't have firewall, check if you have IP address.
if you don't have an IP address, check if the driver of your network card was installed properly.
Let me know if you are not familiar how to check as mentioned above.
Notebook plugged in. cannot get the dell to turn
1. remove all ext peripherals
2. remove battery
3. plug ac adapter to wall socket power (without the laptop)
4. check if the ac adapter led stays on, if yes then connect the laptop, check if the ac adapter led turns off after connecting to laptop, if not then turn on the laptop if still no power then have replace the motherboard.
My m60 just crashed. Memory Full message popped up
Try this fix.....good for windows crashes...
Windows Start-up Errors
Step one, you need a Windows XP CD. If you only have a recovery disk set like the ones from HP or Compaq they will not do what you need done. Under normal circumstances however, you can use a Dell disk because the Operating system is on a stand-alone disk. All retail versions are also acceptable as well as upgrade disks. For a rule of thumb, if the disk has the Microsoft hologram it should work. You can order a boot up floppy disk from here: http://support.microsoft.com/kb/310994 with this file, if you know how, you can use “ImageBurn” to burn the file into an ISO file which can be burned to a disk. Now make sure your computer boots to the cd rom first. If you know how to do this skip on down, if you don’t, while the computer is first starting up and you see the manufacturers splash screen, tap F12 (some computers it’s F9, others it may be another key, you may have to watch and see if the computer lists the key strokes for getting to the boot menu. If you still cannot find it, boot into the BIOS settings and change your boot order there. Save your settings and exit, the computer will now seek the cd rom as its boot source first.
Place your Windows disk in the computer and start it up. When you see the test at the top of the page “Press Any Key To Boot From CD” Just hit the space bar to activate. The next screen you will see will most likely be a Windows setup screen, when you see this press the “R” key to get to the recovery console. It will get there, it may take a little time, patience. Once it loads you will be given a choice of Windows installations, there should only be one, if there are more, always pick number one. It may ask for an administrators password, if you have not set this particular password, then just leave it blank and press enter. The next prompt you see is:
C:\Windows>
You need to type the following:
cd \
hit enter. Pay close attention to the spacing between the characters. There is a space between the character “d” and the “\”
You are now at the ROOT of the drive, this is where basic commands can be given and changed. You should now see the following:
C:\>
Now type the following:
CHKDSK /R
Hit the enter key.
The chkdsk /r command also includes the P command and will also look for lost recoverable information in bad sectors.
There are occasions depending on how corrupt the system is, that this process could take several hours, so be patient with it.
Now, after chkdsk has run type the following:
FIXBOOT
Hit the enter key.
It may prompt you with a warning, that’s ok, just continue. When fixboot has finished, type: EXIT hit enter and windows will reboot. When the system reboots, tap the F8 key during this time and you will see the multi-boot menu come up. Scroll to the title “Last Know Good Configuration” and hit the enter key. If you were having some simple drive errors this should have fixed them.
Laptop New LCD Screen Cycling Colors
It's probably the wrong screen, cable ,or inverter; in spite of what the repair shop tells you .
Also, sometimes the cable gets pinched if not installed carefully, or the cable connector may need to be re-seated.
Is your laptop a Dell Precision M60 ? I'll see which screen it's supposed to have.
M60 battery will not hold charge
if the battery is over 18 months old, the answer is replace the battery. If the battery is NEW then the charging circuit of the motherboard is bad
My precision m60 wont turn on
remove the LCD hinge cover, see if you can turn it on pressing the power button directly. Also the suspend switch in the hinge cover could be sticking.
Problems charging Dell Precicion M60
go to support.dell.com and check your warranty information..thepower cube may be failing..if still under warranty, they will replace free of charge depending on your service agreement
have your express service code ready to put and it will give you all the information you could ever need about your system
www.aa1consulting.com
Dell M60
At the left of your power button, past the word PRECISION, there is a
slot for a screwdriver. With the screen fully open, use that slot to
remove the power and volume buttons. At the other end of the stip you
removed will be the connector that connects the buttons to the
motherboard. Reconnect it better.
Dell M60 volume buttons
At the left of your power button, past the word PRECISION, there is a
slot for a screwdriver. With the screen fully open, use that slot to
remove the power and volume buttons. At the other end of the stip you
removed will be the connector that connects the buttons to the
motherboard. Reconnect it better. I had this problem too.
Dell Precision M60 won't start up
Without battery connected it wont work. Better buy a new batterry connect it and plug it for charging for 8Hrs conitnuosly without switching on the laptop.
How can we connect acer aspire 5001 wlmi to
You have TWO OUTPUT from the laptop: VGA and RCA Video Out (Yellow connector). Now match one of these in your plasma TV and you are on your way to fame. Remember to select the video source on your TV, possibly A/V input.
Not finding what you are looking for?