20 Most Recent Konica Minolta Kip 3000 Series Printer - Page 8 Questions & Answers

The incorrect Image processing board is installed Check connectors change image processing board

service all pick up and exit roller, or check the side door sensor, check of their spring returns.

https://printcopy.info/?mod=srch&inmod=erc&brand=Konica-Minolta&strSearch=Konica+minolta+368+cyan+abnormal+low+toner+density

Recommend a real KMBS tech look at it might need new NVRAM and control board.

Turn off sub power switch not the main! Then press 2 and 5 and turn on the sub power switch which puts you in MODE 25 select #5 Password setting. Then select #1 key operator setting. Default might be 9272.

Code does not show in the service manual correct code and model????

https://www.macworld.com/article/1142068/konica_minolta_1690mf.html

Stick paper clip in tiny hole front or back

tp link adapter

Does it copy? Did update the firmware after installing the new board????? Was it gotten from Konica Minolta???

You don"t buy a new one

What is the model and the code is C8650??????

Registration motor (M5) Printer control board (PRCB) ADU drive board (ADUDB) Any of the one above, but I would start with the Motor check the registration roller its the big roller (length wise prior to the drum section.

Cooling fan on the Main board is in operative. See if you genteelly clean it if not need new board!!!$$$$$$$

Unless you have access to the MY Konica Minolta Web site you will not be authorized to have access to it Copier firmware belongs to Konica Minolta

The model number would help?

Does the first tray display on the control panel or does the machine state that 1st draw is unavailable? Go to service mode and reset the first draw electrically.

Replace the hard drive

Any reset will wipe the memory and network settings so I would recommend you have tech look at it and see if you can save all setting before wiping clean Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Need to access service mode to enter serial number if you don't enter correctly then machine will lock out. I recommend you have a tech do this. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f