20 Most Recent
Gigabyte 7VM400M-RZ (GA-7VM400M-RZ) Motherboard - Page 6 Questions & Answers
How to check warrenty
For Gigabyte mother boards, visit http://www.gigabyte.com/support-downloads/customer-service.aspx for further warranty information.
4/5/2016 11:23:15 AM •
Gigabyte...
•
Answered
on Apr 05, 2016
It runs at first 10 mins then it suddenly turns off without warn?
hi this sounds like you might have either a overheating fault or the "switch" ( not a real switch more like a little silver tube looking item) on the motherboard may be at fault, you need to check the CPU heat sink and fan are up to the job, also check the graphics card if you have a separate one, it might be overheating, turn it on with the case open and just check the CPU fan see if is turning fast or even better still access the bios and go to the CPU utility and check the fan ratio there it shouldn't be less than 2500 to 3500 rpm depending on the board and CPU ok...hope this helps please vote thanks
3/25/2016 8:37:02 AM •
Gigabyte...
•
Answered
on Mar 25, 2016
Since changing the battery on the Gigabyte 8KNXP mboard the SATA Hard Drive isn't being seen. How do I setup the BIOS for the SATA hard drive to be used & seen for Windows to start up again?
Are you sure that the drive isn't being detected but not being SELECTED as the boot drive? Most older MBs will default to the PATA primary cable to search for the boot disk. When you fist boot up, enter the BIOS. If, under the STANDARD CMOS FEATURES option, you do not see your SATA drive listed, then check the data and power cable connections to the SATA drive. If it still is not, there, then, in the CMOS, check under the INTEGTATED PERIPHERALS to ensure that the ON-CHIP SATA option is enables (or AUTO). If the drive IS there, but just not booting, then, under the ADVANCED BIOS FEATURES, check and ensure that the SATA drive is listed as the FIRST BOOT DEVICE. If it is not, follow screen direction to change the first boot device to the SATA HDD.
10/16/2015 5:09:34 PM •
Gigabyte...
•
Answered
on Oct 16, 2015
Have a LG L194WT 1440x900 display but cannot set that resolyution - max is 1280 x 1024 after upgrade from Windows 8 to 8.1
There are two possible issues that can cause this:
- The graphics adapter driver is not correct (using default VGA)
- The OS doesn't recognize the monitor's resolution capability.
Look at the DEVICE MANAGER screen and observe what the display adapter type is. If it is a "standard VGA" then you need to search for an updated adapter for your computer's graphics card or internal chipset (if onboard graphics).
If the display adapter is correct, then check with the LG site to see if there is a monitor driver that can be loaded to aid in the OS identifying the monitor's native resolution. If there is no Windows 8 driver, you can try a Windows 7 driver...it may work.
10/3/2015 5:41:14 PM •
Gigabyte...
•
Answered
on Oct 03, 2015
Not finding what you are looking for?