20 Most Recent
Questions & Answers
Canon pixar MG3122 po2 error code with light flashing
I recently had this error (P02) and found it to be a simple fix. If you open the front where the cartridge runs you will see a clear flat strip that runs from side to side. This strip reads where the cartridge carrier is. If this strip gets dirty the printer will read as a paper jam. There is an area just below that strip that has grease on it. In my case, I accidently touched the two while moving the carrier to replace the ink cartridges. This put grease on the flat clear strip. Once it was clean my printer started working again. The easiest way to clean the strip without taking your printer apart is to use a Q-tip and clean with gentle strokes from side to side.
I really hope that I have helped at least one person with this post!
ERREUR 11 SUR SMITEC COSMOS 2000
This is a Hall Encoder loss signal. Probably u dont have one connected, so it shows Error 11...Connect the encoder (Hall Effect) to disable this fault.
Not finding what you are looking for?