Panasonic Palmcam PV-DC2090 Digital Camera - Page 7 - Answered Questions & Fixed issues

You should go to the shop where you bought it and ask tem. Even if no one knows Japanese, probably they know the steps

Search "error code ***** + your make & model"

it uses alot of power to transfer like that

If you could turn it on before and now, following same procedure, you can't turn it on, probably it is no working and you should take it to repair

read YouR mANuAL, PANASONIC NV GS22 Operating Instructions Manual

What kind of camera? Just because it's a Panasonic all of the batteries are not the same. The original battery will have a code on it.

remove the battery. When it comes on when you reinsert the battery, tho on of switch is blocked in the on position. When after reinserting the battery you can't switch the camera on the switch is just defect. Sorry in both cases you have to consult a tech, the dealer, or a Panasonic certified repair centre. Let us hope the camera is working ok after this.

Use hand set , & find settings that should come up on TV screen

Please try again on their website. We only try to answer questions, we don't register cameras for any firm. We don't send e-mails. Sorry.

Here you have the official from Panasonic. You need a PDF reader, like acrobat reader from Adobe (also free), to open the file. https://panasonic.ca/PCS/OperatingInstructions/DMCTZ1-OI-eng.pdf

No problem, free on this Panasonic link: http://service.us.panasonic.com/OPERMANPDF/DMCG2K.PDF

Free download from Panasonic here: http://service.us.panasonic.com/OPERMANPDF/DMCG2K.PDF

Try here http://www.ps2netdrivers.net/manual/panasonic.cn-hw830d/

Hello I suspect that this refers to the locking slider on your SD card in the camera. Most have a little slider on the opposite side to the cut-off corner of the card. On some cards it is very easy to slip this into protected mode when inserting the card into whatever apparatus is being used, your camera for example. Make sure that this slider is in "unprotected2 mode before going any further Hope this is helpful, if so would you please register that with Fixya Cheers

Always be sure the batteries are charged and suited for your device. Check contacts of the batteries and in the battery compartment of your device. Dirty or oxidised contacts can be cleaned with a dry cloth, or a cotton swap. Never use sharp tools to clean contacts or anything sharp in or on electronic equipment. Always charge batteries before using it for the first time, or if you have not used it for a long period. 3 months is a very long period. Always charge sets of batteries (2 or 4) together. Do not use alkaline batteries unless it is absolutely necessary. In some cases, alkaline batteries may have a shorter service life than NiMH. Alkaline battery performance is limited, especially at low temperatures. The use of NiMH batteries is recommended. NEVER use manganese (Zinc-Carbon) batteries in electronic devices. These batteries are only to be used in flash lights.

http://www.manualslib.com/manual/360843/Panasonic-Lumix-Dmc-G2.html?page=39#manual

Sometimes the chargers blink to let you know they are working, then light up solid green when the battery is fully charged

If there is no problem with the actual picture and only a focus problem, it can be that the focus motor needs replacing, worm gear needs cleaning and greasing or an electronic alignment needs to be done on the camera.

Call 1 800 211 7262 and panasonic will walk you through that. You can also go to panasonic.com and scroll down and look on the right side for manuals and product registration. The manual will show you how to do the reset but the 800 number may be even better.

1. www.panasonic.com/uk/support.html Try the web site: Panasonic . com / UK / support html and see if they can fix your system.