20 Most Recent Tecnik TKL9290 Front Load Washer / Dryer Questions & Answers

Could be worn carbon brushes, or possibly defective shock absorbers

If your dryer is electric: need to check for two things: bad over-temp thermostat (open)...or...open heating elements. If gas, check pilot and/or auto firing circuit.

Two options: 1- Heating element is dead. 2. Thermostat is faulty. this unit is normally located on the inner surface of the drum and can be easily accessed after removing the rear cover. It is normally installed in a rubber housing. Good luck.

no drain then no spin check the filter and also if there is a foreign object jamming the drain pump impellor

Hi from retired Englishman in SW France,

Sorry but you must realise that with such a fault it is virtually impossible for anybody on this FixYa forum to guess remotely what is wrong with your washer.
It could be internal wiring/plugs sockets, control panel switches, control PCB, water inlet control valves, door solenoid, main motor, drain motor etc..

I fear that your only real option is a service call as the engineer will have the right equipment to safely diagnose what is wrong.

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C

I have checked every manual database I know, no luck. You could contact Tecnik directly and ask them to assist. Contact details are below (UK numbers so drop the lead zero and add +44 if you are outside the UK):

Office Hours: 9am - 5:30pm Mon - Fri Trade Sales: 0161 786 4692 Appliance Care Service: 08705 678910 Spares: 08705 543210 Whirlpool Service Service & Spares: 0870 600 8989 Rangemaster Service Service & Spares: 0845 603 5312
Office Hours: 9am - 5:30pm Mon - Fri Trade Sales: 0161 786 4692 Appliance Care Service: 08705 678910 Spares: 08705 543210 Whirlpool Service Service & Spares: 0870 600 8989 Rangemaster Service Service & Spares: 0845 603 5312
Service & Spares: 0845 603 5312Service: 08705 678910
Spares: 08705 543210

The bearings are more than likely going bad.

Hi from retired Englishman in SW France,
???
I'm so sorry but this forum is not able, nor in a position, to supply any type of manual, parts list, installation instructions, electrical or schematic diagrams direct; it's just made up of ordinary guys and gals, probably at home and from all over the world, with experience of addressing problems and giving guidance for free on the web ;-0)
Also members on Fixya are not 'affiliated' to, or representative of, any manufacturer at all, just using their experience gained probably over many years.

Manual
You will need to type into your search engine/web browser '(make model number) washer manual' and you should be presented with a number of sources from which you can either download for free or have to pay a nominal amount.
You could also try the manufacturer's web site direct ;-0)

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

If you leave it on its own, how long/will it ever, advance on its own?

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101


jfk