Connex Cx-3600Hp 3600Hp 10 Meter 100 Watt Cb Radio - Page 2 - Answered Questions & Fixed issues

first of all if you do not have a ham license then you should even worry about getting on any band other than the AM band .

Your connex should have a know with letters on it A,B,C,D,E,F, Look at the counter and set that knob to C whick should be the CB frequency.

Hello As a general rule of thumb all radios should be connected directly to the vehicle 12 battery. This connection cuts down on vehicle induced noise and allows the radio to have access to the full current it needs to operate at full efficiency. Make sure there are matched fuses in the positive and negative leads going to the radio. Hope this answers your question.

On the RF Hi Lo switch do you have power? Is the switch ok? That switch regulates the TX power and if it is open, you have none.

lack of a noise filter on the DC voltage supply to the radio http://www.jaycar.com.au/Sight-%26-Sound-Car/Car-Audio-Hardware/Car-Hardware-Accessories/10A-DC-Noise-Filter-(Improved)/p/AA3074 or lack of grounding maybe https://www.youtube.com/watch?v=dY3gD-j4SVs

Yes.

1 ground 2 audio 3 tx 4 rx - exports do not use

Is there any RF being transmitted, to a nearby radio. also does the TX/RX led change. There are many scenarios on this.. Loose/cold solder joints on the board. loose diode on solder side of the IF area.. Bad RF transistors from High SWR.. if you can provide more info.

If you must use echo.. please use a dummy load. while adjusting the amount of echo.. you want it to be intelligible to the other listeners.. just barley add the echo effect and it should sound great and not like your in a can or all running together were no one can understand you...

http://www.radioaficion.com/HamNews/mods/mods-cb/8264-galaxy-saturn-service-manual.html

http://www.fixya.com/answer/answerpageslideview.aspx?ctg=89&fml=0&brd=3150&thid=23542883

To recieve signals on 10 or 11 metres with the same antenna is usually without problem, it's when you try transmitting that the correct antenna length is vital. If it's not correct, you can , at the least, get very little power being radiated, and at worst, the power going back into the transmitter and cooking it. If you have to ask these questions, you should not be on the 10 m amateur band anyway.

Check for a Bad, whats called the AM regulator on the back corner of chassis by pwr connector. 2sa or 2sb styles. 2sb817 if available is a good $3 replacement.

8v 1 amp to-220 package. any package would work. just make sure its rated at 1 amp or more..

you should have saved your money and bought a noise toy instead. they just plug into the back of the radio and your coax from the antenna plugs to it.

Try replacing battery behind channel selector

A qualified cb radio technician can do it.

small watch like battery located behind channel selector

There are many reasons for it to blow a fuse .Putting one in that is higher in amps won't help ,all it will do is prolong the reason it is blowing fuses. One reason could be IC 5 thats blowing them.

yes but you will have to take it to a tech and let him do it because of process to do the repair.