20 Most Recent Behringer Pmp4000 Europower 1600-watt 16-channel Powered Mixer Pro Dj Club Stage - Page 7 Questions & Answers

You will probably need a voltage converter. Unless you purchased the general export model with a switchable voltage power supply, your PMX2000 will have the power supply for the 120V 60 Hz electrical mains and a 10A H fuse. To confirm this, look on the back of the amp. I wish that I had better news for you. Cindy Wells

Not untill the fault is cleared, which will I suspect be a shorted part in either the main amp section or power supply section though I don't believe it will be in the power supply.

Any good electric part shop should stock the fuse. I assume the 10H means 10 amps and the last bit 250 volts.

hi,Fuse breaks when it has succeeded in limiting further damage.Check for other possible shorted electrical and electroniccomponents.• Could be drive transistor , output transistor or both on the main amp.But check for power supply and in the preamps also.• Measure supply voltages, • Check DC offset voltage • Check idling current (main amp)Isolate , and trace afterwards.

Hi,These resistor would normally heats up.( if it wouldn't, it is not doing the job)But if there is no regulated 15Vdc after the regulator IC2 , you know what it means.thanks for choosing Fixya for assistance.

Possible that the power section has failed and it could be due to fault in the power supply section . Unless the unit is opened the damage cannot be confirmed to be just a fuse or a faulty SMPS.

EEPROMs do not need changing or swapped out they only need to be programmed to be updated.