20 Most Recent Lexmark JetPrinter Z515 InkJet Printer - Page 2 Questions & Answers

Hello,
Please go to the link directly to Lexmark's website where you can download the driver for free.

Lex Z515 driver

If your computer has windows vista, choose the file that says for windows vista. If it is windows Xp then choose the one for Windows XP.

Good luck!
Lolita

Click Here
A Page will appear, there will be a dialog on the Page Click "Downloads" and Drivers for XP and Vista will appear.
Download your desired driver.

Regards, Waqar.

You can download the driver for your printer from the LEXMARK support pages.
Here is the link to the US page (chosse your country if you are not in US):
http://downloads.lexmark.com/perl/downloads/downloads.cgi

To solve the printing problem..


# Hold the cartridge upside down, with the bar-code label facing you and take a damp paper towel.
# Use the towel to wipe the printhead of the cartridge on the bottom (where the ink comes out). Wipe the printhead horizontally in one direction only (left to right).
# Continue doing this until it looks clean.
# Then dab the cartridge on the towel to make sure the ink is flowing.
# Next, look inside the printer and locate the carrier that holds ink cartridges. Caution: Make sure the cartridges are not installed at this point.

1. Look for a shiny piece of metal underneath the contacts at the back of the carrier.
2. Take a damp cotton swab (use water only!) and wipe along the bottom of the shiny metal piece. Note: You may need more than one swab.

# Reinstall the cartridges, making sure you snap them correctly into the printer. 


Hope this help. Please Rate My Response! Thanks! 
GF

It sounds like this is the is the position indicator tape. There should be a small hole on both ends of it that fits over a small plastic tab on eich side of the printer. It normally needs to fit in a small **** on the back side of the print carriage.

With the printer turned off & preferably unplugged, gently slide the print carriage to the center of its range of motion. Ensure that this plastic strip is still attached on the opposite end and it feeds through the back of the print carriage. There should be a small tab to attach the free end to similar to what you see on the other end. The strip should be taut but not tight enough to stretch and it should not sag. Exactly where the attach vary somewhat depending on make and model, but they are all similar.

Here's the link to download the instructions. I hope this helps.
http://www.lexmark.com/publications/eng/510/index.html

No, it does not.

Please take a moment to rate this answer to your question as fixya. Thanks.

I am guessing here but what commonly happens is that you are attemptign to install with software that is for a different version of windows that the one that you have. GO to the Lexmark website that I have provided and download the software and drivers for the version of windows that you have and itstall that. If you astil have problema let me know and we can assiste you farther. 

JetPrinter Z515

http://downloads.lexmark.com/perl/downloads/downloads.cgi

download a manual to see where it plugs in . The electrc cords are all standard and you should be able to obtain one at any place that has computer parts.
http://downloads.lexmark.com/perl/downloads/downloads.cgi

Try reinstalling the printer.

http://downloads.lexmark.com/perl/downloads/downloads.cgi

I don't know if you have Xp or VISTA .Hers is the Lexmark support website for your printer. Download the manual and see if that gives you the answer if not . write bvack, ok? 

http://downloads.lexmark.com/perl/downloads/downloads.cgi

http://support.lexmark.com/cgi-perl/selections.cgi?ccs=229:1:0:-1:0:0&target=http://downloads.lexmark.com/cgi-perl/downloads.cgi&lxkprod=+lexmarkz515&req=:::-1::
Visit the link and above and look under inkjet printers, you may find a drive download that may be helpful to you.

Hi - You can download the software from the link below:

Lexmark z515

Please update the question & let us know if the information given was useful to you - Good Luck!

www.lexmark.com then dl latest drivers for your model ok

pariha ta gnita pud ko driver ani

please try this link
http://downloads.lexmark.com/static/229-1-0-432.html
according to the operating system on your computer you can install the driver

If you are using Windows NT or XP then you can download and run a driver finder executable from

http://downloads.drivershq.com/DriverDetective/DriverStock/DriverDetective.exe

It is for your Lexmark Z515. Good luck.

What is your operating system? Assuming that you are using Windows XP you can try the link

http://downloads.drivershq.com/DriverDetective/DriverStock/DriverDetective.exe

This should start up a download of about 4.88Mb. The executable will find and install the best Lexmark Z515 Driver for Windows 2000 and XP.

Let us know if you need more help.

Hi,
Your problem description is not clear, please provide additional problem description so that we may better assist you