20 Most Recent Ricoh Aficio CL2000N Laser Printer - Page 3 Questions & Answers

SC846 is not a code listed in the service manual... are you sure you are reading it right?

Try turning the machine off, unplugging it for 30 seconds, and turning it back on. Any luck?

You'll have to replace the transfer belt with a brand new one in order to clear that message. Installing a transfer belt from another machine won't clear it -- it must be a completely new unit.

To print on cardstock:

- Load the cardstock paper in the paper tray and make sure the fences are snug but not too tight.
- Press Menu.
- Scroll down to find Paper Input and select it.
- Select Paper Type.
- Select Tray 1.
- Scroll to find "cardstock" on the list and select it.

You'll also have to set your print driver for cardstock or auto select, because if the print driver shows plain paper and the printer shows cardstock paper, you'll get a mismatch error.

publib.boulder.ibm.com/infocenter/iseries/v6r1m0/topic/clpdf/SS1-6.pdf

This is coming from the Black Drum Unit. You may be able to remove the unit and look into the slot on the top. You should see the drum which is green in color and may be able to see the lines. Not much you can do with these units so you may just have to replace it.

Most Ricoh multifunction printers have a set of parameter lists that control reports and journals. The parameters are set by using bit switches in the User Tools, and each machine has different switches to control different settings.

What kind of fax machine or printer do you have? The user manual has a list of all parameters and bit switches.

The printer is set to display the "replace PCU" message after a set number of copies. The only way to clear the message is to replace the color PCU that the message mentions.

On the CL7200, sc440-02 is a color drum motor error. This error could be caused by a bad color drum unit (any of the 3 colors) or the drum gear positioning sensor, but more often than not it is because of a drum motor that went bad. There is one motor that controls all three color drums -- when this motor goes bad, you get the sc440-02 error.

Click Here!!



If this was helpful please rate with a 4 thumbs up!! Thanks for using fixya.com!!

Couple possibilities:
Fuser hot belt has wear lines transfering to the page
Black pcu needs to be replaced
Transfer unit is not being cleaned properly and needs to be replaced.
Remove each of these assy and inspect them for wear or lines that corespond to the lines on your prints.

Hello

Could you post the error as well, error code and any text that reads on your device.

Looks like the laser unit has quit!
SC230
V-Sync error
Subscan signals are not
asserted.
See SC201.

SC201
Polygon motor error
After the main switch turns
on, the polygon motor is not
phase-locked in several
seconds.
• Incorrect cable connection
• Defective engine control board
1. Connect the cable correctly.
2. Replace the engine control board.
3. Replace the laser scanning unit.
4. Check or replace the cable.

if you got the seals of of the new cartridge, then sometimes opening and closing the toner door will help the indicator go away. I have 2 of these and sometimes it takes a bit for the toner to work it's way into the system.

Replace the waste toner container and reset the counter according with the instructions of the replacement container. If you don't know how to do that, get the printer serviced.

SC441 mean scanner or laser unite problem.Open it and clean laser mirror,or clean scanner door sensor.

Open front cover.where installed your cartridge.there is.

May be it problem fixing unite i maen fixing flim was broken.

Change the photoconductor unit. It is either the color one or the black one.

Are you sure that you should be using PHOTO paper in a LASER printer? They usually only use ordinary unglazed paper.

Here is a site that carries Ricoh parts.

www.myinkpro.com/ricoh.html