20 Most Recent Ricoh Aficio CL7000 Laser Printer - Page 7 Questions & Answers

Find the code meaning and it might help finding the problem. https://printcopy.info/?l=en&mod=erc&brand=Ricoh

Go to this site. https://printcopy.info/?l=en&mod=erc&brand=Ricoh

Buongiorno , hai provato a pulire il sensore dietro la cinghia di trasferimento?

check the contact of your charge roller in yellow PCU

AS I understand you have black stripes on the back side of the print, so if this is the case, the Image transfer cleaning blade need to be replaced. Part number is: Genuine Ricoh Aficio 2238C Transfer Belt Cleaning Blade Ricoh AD04-1081, AD041081

This is a fuser fault code. First need to check and repair fuser. Buy a new or rebuilt fuser or replace items that cause problem could be thermistor needs to be replace to over temp sensor is bad and needs to be replace or lamp. Once replace then you can clear code. You can buy. Service Manual will explain how to get into service mode and reset fault code. Or post how to reset code on web

print anable 6a

When you replace developer, make sure to clean the waste toner path on the PCU. Waste toner in combination with new developer causes trouble. After replacement of the developer use a piece of paper to block waste toner from falling into the DV-Unit. Then run SP2-801 and do process control. Then make 100 copies and after that remove the piece of paper. A Ricoh tech told me that the amount of toner in the developer can be very high, so he always made 100 copies before removing the piece of paper. I'm doing this for a long time and I never had trouble with SC's related to TD-sensor.

Replace developer, clean ID sensor

The machine will automatically reset the maintenance message when the fuser is replaced. There is a looped wire on the fusing unit connector containing a thermo fuse (a thin wire that quicly melts, and then short the cirquit). If you don't want to replace the fuser yet, you can probably set the machine to meter charge, SP mode 5930, and then reset the maintenance counter with SP mode 7804. You can of course take out the fuser, and replace it with a dirt cheap thermo fuse bought from Ebay. Then set the fuser back into the printer, and it will clear the maintenance message automatically. Either way should work fine, at least it used to do that on the previous model - and it is almost identical.

where about is it jamming - copy 1 sheet and see where it stops.