20 Most Recent Bowflex Xtreme 2 Home Gym Pre-Owned - Page 6 Questions & Answers

Dear Sir:Inspect the bottom of your treadmill console.Use the pencil point. touch the hole(nano swithc) and ready. Of course you must disconnect the power before. After you reconnect it. And ready.sincerely. God bless you.ernesto cuadramanagua, nicaragua. c.a.

Dear Sir:
Thank you by your question, and I will try to help you.
1) The power button may is defective or dirty contact.You must turn off the power( disconect the power cord) 2) Clean with special spray for lubricate switch, etc( Radio Shak or other Electronic Shop) you can use too alcohol isoprophilic to 100% very effective!.
3) Try to probe again, conect the power cord.
4) If not solution with this, reset the circuit breaker, and try again.
5) Measure with DVOM, the transformer, and see very carefully if there are Input to the transformer and output from the transformer, check any electronic component around of it. See if there are some smell to burn( like capacitor, diode, resistor, transistor, or some faulty cold solder) and fix it.
6) If everything is o.k your problem will be in Relais or contactor for the main motor, try to clean the relais or contactor, very carefully, disconnect the power cord, and clean the contact with special spray for electronic contact, or use the alcohol isoprophilic 100% . 7)Try again, if after check all STEP, mentioned before the problem is the PCB, you must contact to the factory for replace the PCB.
Thank you in advance, sincerely. Blessing. If you neee additional help, you can reach me. E.CUADRA MANAGUA, NICARAGUA. C.A.

Dear Sir:

1) If everything is working , now the only thing you can do:

2) check the Motor Lift the Voltage DC ( direct current) is diffferent from the Motor Drive that work with 115 VAC( Voltage alternating current). See the Voltage in the plate of the Motor if 48Vdc or whatever voltage is indicated.

3) Check the breaker and reset , and clean with solution with 50% oxigened water and 50& ethilic alcohol (100%).

4) If all is clean, turn on the motor Lift, and See if there are voltage and the terminal Motor( Check with VOM-Voltimeter in the range DC,) .
Check again the voltage indicate in the plate of Motor, if the Motor is NOT Working, the Motor is Bad( Some brushes wear, and winding overheating) replace or repair.

Conctac me, if you need some additional Help.

sincerely.

Have a great time, blessing.

E.CUADRA

There are basically two cases behind this problem and youneed to check them properly: 1. Your treadmill is most likely equipped with a heat sensorwhich shuts down the motor and/or electronics to prevent them from burning up.If this is the case, replace the walking belt. Be sure to inspect the deck forwear too. If you want to go for a cheap fix try lubricating the walking belt.The best fix is to replace the walking belt and then regularly maintain it andkeep the treadmill clean. 2. If first step seems ok, then it's either a loose wire, anintermittent short, a bad power board, or a bad control panel. Unplug yourtreadmill and then check all your wiring to make sure nothing is pinched,crimped or loose. Remove and replace each connector in case corrosion iscausing the problem. If the problem persists, you most likely have a badcontrol panel or some call it a console. Hope this will help you. Good Luck.

Was just looking for the same thing myself. Go here and search for bullworker:-
http://www.sandowplus.co.uk/whatsnew.htm
I needed to download the pdf file to see the full manual.

A twisted strap means that it's life is over. You must change it. Even if you keep putting it on the pulley it will keep coming off. To stay on the pulley it must be strong enough not to get twisted.

There is probably a short circuit in the power supply but most electronics engineers can fault find and repair the old board. Look for a short circuit across C17. If there is, check T1.

All question need full 'make model (what it is)', Margaret, first 3 words or this happens.

Fluke BT5300 Series Battery Tester

Fluke https://www.fluke.com > product > battery-analyzers Specifications: Fluke BT5300 Series Battery Tester ; BT5310/BT5311, BT5320/BT5321 ; Digit, 6.5 digits, 7.5 digits ; Range, 10 V ; Max. Display value, ±11.00000V · ± ...

(BT) Air Baltic 5310 Flight Tracker

FlightStats https://www.flightstats.com > flight-tracker BT5310 Flight Tracker - Track the real-time flight status of Air Baltic BT 5310 live using the FlightStats Global Flight Tracker.

Airbaltic BT5310 Flight Status

Trip.com Official Site‎‎ ' Travel Deals and Promotions https://us.trip.com > ... > Flights from Munich to Lisbon Track real-time flight status of BT5310 from Munich to Lisbon on Trip.com. Get live updates on flight arrival & departure times and other travel information ...

QC620 Skid Digger Thumb

GLC Equipment https://www.glcequipment.ca > product > qc620-skid-dig... SKU: BT5310 - 48 Category: Back Trenchers. MPN: BT5310. Manufacturer: Wallenstein. Brand: Wallenstein. Description; Additional information; Reviews (0) ... $910.00 · ‎ In stock

BT 5310 - Aluminum Komatsu WA450-6 Wheel Loader ...

C, G, & J Inc https://cgj.com > product > bt-5310-aluminum-komatsu... BT 5310 - Aluminum Komatsu WA450-6 Wheel Loader Radiator. $1,404.75. The BT 5310 all aluminum radiator is an exact fit, OEM replacement for Komatsu WA450-6 ... US$1,404.75 ..

CHECK WITH THE PLACE YOU GOT IT