20 Most Recent
ZTE Warp - Page 2 Questions & Answers
Zte warp phone stuck on android logo
1.Power off the phone.2.Press and hold "Vol+", "Menu", and "Power" key until the phone goes to recovery mode.3.Use "Vol+" and "Vol-" to move the cursor up and down.4.Move cursor to "wipe data/factory reset", press "Back" key to select it.5.Now move cursor down to "Yes - delete all user data" and press "Back" to select it.6.The data will be erased.7.The cursor will be on "reboot system now" at the end, so just press "Back" key to reboot the phone normally.WARNING: All user data will be completely cleared; the phone will be in a factory reset status.
3/17/2015 11:19:31 PM •
ZTE Warp
•
Answered
on Mar 17, 2015
My zte wont turn on all the way
1.Check the device's battery level for at least two bars of strength. 2.If the battery level is low, charge the battery. 3.If the issue is not resolved, remove the back cover. 4.Remove the battery. 5.Wait 10 seconds. 6.Press and hold the W key. 7.While pressing down the W key, re-insert the battery. •The device restarts and after approximately 15 seconds, the 'Recovery' screen appears•Release the power button but *continue holding the home button*, for another 30 seconds.StepThanks
3/8/2015 3:24:31 PM •
ZTE Warp
•
Answered
on Mar 08, 2015
My zte majesty got wet, put it in rice, phone turns on but screen is black?
looks just like any other electronic device, I suggest that you clean it. It really does not matter how much water exposure it had, or how long the exposure was. what matters is which part was exposed. Disassemble your phone and clean every part, connector and cable with 90%+ isopropyl alcohol. Make sure that you remove any EMI shield. Use a soft brush to clean the connectors and cable ends properly. Check for missing or burned components. Once it is cleaned, replace the battery. After that reassemble your phone and re-evaluate. Until you know for sure that it is clean, any answer will most likely be a guess only. Hope this helps, good luck.
6/26/2014 3:16:54 PM •
ZTE Warp
•
Answered
on Jun 26, 2014
Not finding what you are looking for?