20 Most Recent LG WD-80130F - Page 8 Questions & Answers

NP should be a No Power code. Check if any wire is burnt past the plug (dryer side). Sometimes the wire burns out at the element. Don't poke around inside with the power on.

lc is of Child Lock and can be set by squeezing the PRE-WASH(*CHILD LOCK) or TUB CLEAN(*CHILD LOCK) for 3 seconds At the point Child lock is set, To unlock Child Lock system, press the same button again.

possible drain hose blocked or bad pump

Check to see if child lock is on

The error code "PE" stands for pressure sensor error. This is typically caused by a malfunctioning water pressure sensor switch.

Would not finish the rinse cycle. I replaced the water inlet valve which solved the problem. Same problem again. I replaced the water inlet valve but now it doesn't start.

I agree bad timer call a tech still b cheaper to replace than buying a new unit

If the drum has dropped 4", they is a catastrophic failure below it.

If your washing machine cannot either drain or spin then the water level control could be faulty. Open up and look at the washers control panel and also look for a plastic tube attached to the water level valve. If appears to be clogged clean it out with vinegar. If the valve itself is broken or rusted then. it may need to be replaced.Have a person that repairs washing machines to have a look at it.

contact a LG dealer for part number and price

Many things to cause that. Put sheets of newspaper slid underneath between the feet. Run a wash, slide the paper out every 10 minutes to locate the area where the leak is. Wait for the cycle to finish. Pull the machine out and tip it towards the wall. Make sure it won't fall forward by getting someone to hold it. Could be; hole in the drum. leaking pump leaking hose clamps perished rubber pipes leak in the drain hose The wet spots on the newspaper will pinpoint the leak area. ..

most likely bearing problem

possibly the bearing seal is gone , suggest calling a local repair service

Solution. Unplug the machine. Hold the power button for 10 seconds. Plug back in. Push the power button and the washer should turn on. Walk away leaving the machine on. When I did this, I came back to find the drum light off and machine would start on command now. Good luck.

SUSPECT DOOR LOCK IS NOT WORKING

A domestic appliance repair company may be able to source the spares for you and possibly fit it.Spares are not likely though as door inners don't break whilst the machine is under the manufacturers warranty so spares are probably not available.

you need to define where it is leaking from as we cant see it.

Look inside for the missing fasteners/ screws

Look at where it is leaking from, possibly under the drum.

that is strange, either your filters on the hoses are blocked or your water inlet valve is failing. Worst case scenario, it is the control board!