Top 20
Samsung RF266ABRS Bottom Freezer Refrigerator French Door - Page 2 Questions & Answers
HOW TO TAKE DOOR HANDLES OFF RS263TDWP SAMSUNG FRIDGE MAYBE BUILT IN 2011
To remove the door handles on your Samsung RS263TDWP refrigerator, you will need to follow these steps:
- Locate the screws that are holding the handles in place. The screws are usually located at the bottom of the handles, near where they attach to the door.
- Use a Phillips head screwdriver to remove the screws. If the screws are stuck, try tapping the screwdriver gently with a hammer to loosen them.
- Once the screws have been removed, gently pull the handles away from the door. If the handles are difficult to remove, you may need to gently pry them away from the door with a flat-head screwdriver.
- Repeat the process for each handle.
Note: Be careful not to damage the door or the handles during the removal process. If you are unsure about removing the handles, it may be best to contact a professional for assistance.
2/13/2023 4:50:59 AM •
Samsung...
•
109 views • 0 helpful votes
Samsung Fridge Freezer Model rt77kbts leaks water
i had this problem .. there is a drain in the freezer it drains condensation through a hose to a pan at the bottom where there is a fan .. that fan splashes this water onto the condenser coils to cool them.. if that hose gets plugged then that water gets diverted and drains into the inside of the fridge... the big problem is this water is no longer cooling the condenser coils and your condenser will run hot until you clear the clog and get this working right again.. i had to unplug the fridge and let everything get warm (a few hours) then run a flexible wire through the hose at the bottom (fan) to the top to loosen the clog then run clean hot water through it to clear it completely . it's no small task but you might have saved yourself buying a fridge and loosing all that's in it ..
12/12/2022 5:20:54 AM •
Samsung...
•
495 views • 1 helpful votes
Samsung rf220nctaww freezer is too cold
If your Samsung RF220NCTAWW freezer is too cold, there are a few possible causes and solutions:
- Check the temperature setting: Make sure the temperature setting is set to the recommended level, which is typically between 0 to -5 degrees Fahrenheit. If it is set lower than recommended, adjust the setting to the recommended level.
- Check the door seal: A damaged or poorly fitting door seal can cause the freezer to be too cold. Check the seal and make sure it is clean and undamaged. If it is damaged, replace the seal.
- Check the thermostat: A faulty thermostat can cause the freezer to be too cold. Test the thermostat using a multimeter to determine if it is functioning properly. If it is not functioning properly, replace the thermostat.
- Check the defrost system: If the defrost system is not working properly, it can cause the freezer to be too cold. Check the defrost heater and thermostat to make sure they are functioning properly. If they are not functioning properly, replace them.
If none of these solutions work, you may need to contact a professional appliance repair service to diagnose and repair the issue.
2/18/2023 10:54:55 PM •
Samsung...
•
44 views • 0 helpful votes
Metal strip on samsung cool select drawer slider came out
If the metal strip on your Samsung Cool Select Drawer slider has come out, you may be able to fix it yourself with the following steps:
- Remove the Cool Select Drawer from the fridge.
- Locate the metal strip and examine it to determine how it came out. If it's bent or damaged, you may need to replace it.
- Reattach the metal strip to the slider by sliding it back into the groove in the slider. If it's loose, you can use a pair of pliers to carefully bend it back into place.
- Once the metal strip is back in place, slide the Cool Select Drawer back into the fridge and test it to make sure it's sliding smoothly.
If you're unable to fix the problem yourself or the metal strip is damaged beyond repair, you may need to contact Samsung customer support or a professional repair service for assistance.
2/14/2023 4:40:58 PM •
Samsung...
•
46 views • 0 helpful votes
How do you take the back panel off inside of American Samsung fridge
To remove the back panel inside an American Samsung fridge, you will need to follow these steps:
- Unplug the fridge: For safety reasons, make sure to unplug the fridge before you begin.
- Remove food items: Take out all the food items from the fridge and place them on a table or counter.
- Locate the screws: Look for screws on the inside walls of the fridge that hold the panel in place. They are usually located on the sides of the panel near the top and bottom.
- Remove the screws: Use a screwdriver to remove the screws and keep them in a safe place so they do not get lost.
- Release the clips: There may be plastic clips holding the panel in place. If so, gently push the clips in with a flathead screwdriver and pull the panel away from the wall.
- Access the back of the fridge: With the panel removed, you should now have access to the back of the fridge where you can place the steamer to melt the ice.
- Reassemble: Once the ice has melted, reattach the panel by securing the screws and clips, plug the fridge back in, and return the food items to the fridge.
Note: Make sure to follow all safety precautions and wear gloves if necessary to avoid any potential hazards, and if in doubt, it may be best to consult a professional for assistance.
1/31/2023 4:06:16 PM •
Samsung...
•
61 views • 0 helpful votes
Not finding what you are looking for?