20 Most Recent Logitech S200 Computer Speakers - Page 7 Questions & Answers

It will never fit because that surround system was made for an audio card for desktop computer. Green is main, tan is surround and black is bass or woofer. There hasn't being any adapter yet for this type of configuration, sorry.

there is two wires and two point of contact, in better speakers it is relevant where these are connected in standard speakers it is not. just solder them in and that is all, you should find small connection plate (insulated!) on the back of the membrane crate, that is where they go.

YOU DONT WANT

Get a MINI usb cable, much like one from a phone charger, that fits the harmony. Go to myharmony.com click support and follow the instructions.

Need more info! What is plugged in to! Your computer? Be sure it is plugged into the right place! The Green outlet on the computer is for sound out! Hope that helps!

all headsets feature what I think is called side tone. you need to hear a bit of yourself when speaking on a microphone as a bit of communication reassurance. When thew microphone level is up way too loud , that's more than side tone, it's annoyance that's when you get the problem that you've listed. I've seen it on telephone headsets and Mobile Phones but i'm sure it would happen on gaming headsets too...
Good Luck

Humming is usually caused by a bad capacitor on the power supply board. Look at the caps on the board, any that are puffed up, burned or leaking (brown at the base) need replacing. Make sure you get the EXACT same capacitors and pay attention to the orientation so you get them back in properly, if you don't you will fry them soon as you apply power to the board.

Check the speaker cables for connectivity. Be sure to securely plug in the stereo jack/s at the back of your pc

Flash drive?Why?On the mp3 use a 30pin to headphone adapter.

The inputs are the Apple port (on the top) for iPod or iPhones, and the Auxiliary input for other digital music devices. You will need a 3.5mm headphone cable. The auxiliary input is located located just above the power connector on the back. If you have a musical device that uses flash memory, then Yes you can. If however if you are reffering to a USB type of flash memory, there is no port for that.

The cost is too great to repair.

Hi, can you put the system in standby? If you can, then try a system reset. While the pod is in standby, hold input and settings on the pod unitl the firmware shows up. Also make sure the control pod is adequately ventilated.