Sears Garage Door Carriage Trolley Assembly - Page 7 - Answered Questions & Fixed issues
Tenpro garage door opener
There are 12 DIP switches inside the motor compartment, which correspond to the switches in the remote. For access to the switches remove the panel at the left side of the motor (1 screw) and you will see the circuit board with the switches
4/24/2021 9:23:00 AM •
Building...
•
Answered
on Apr 24, 2021
•
2,871 views
Liftmaster garage door opener. Why did it stop working?
Flashing lamp typically indicates safety sensors are misaligned. The up/down arrows on the unit will flash codes that are more descriptive. Download your owners manual from;
https://support.partner.liftmaster.com
12/19/2020 12:24:27 AM •
Building...
•
Answered
on Dec 19, 2020
•
59 views
My Craftsman Garage 1/3 HP hbw0777 door opener suddenly won't close after my wife hit the remote a few times as she was trying to open the other door...
Observe the green receiver sensor while the door travels. If it blinks, then likely the optical sensor is causing the door to return to open and flash for 5 seconds.This could be caused by poor sensor alignment or a loose track or loose sensor mount or poor wire splice if not a single length.
You can check receiver sensor alignment by slowly moving your hand, open palm, towards the center of the receiver blocking the transmitter emitter mounted to the opposite track.
Check in two axis, front-back and top-bottom. If aligned properly, the green lamp will turn off as your hand reaches near equadistance to center of the receiver regardless of direction.
9/30/2020 11:12:35 PM •
Building...
•
Answered
on Sep 30, 2020
•
281 views
Not finding what you are looking for?