Top 20 Samsung BD-P1580 Blu-Ray Player Questions & Answers


Try updating the firmware.

Samsung BD-P1580... | 132 views | 0 helpful votes


This sounds like the Actual dvds or corrupt. If they are copies they may not play well.
I hope this helps.

Samsung BD-P1580... | 467 views | 0 helpful votes


Some tv sets from the old days used to have a sound only option - these were almost exclusively dedicated to local cable networks such as Rediffusion.

To the best of my knowledge, today no such sets offer that facility as even the audio only digital channels want their audience to see the logo and be able to access the programme schedules and other information.

If you want to kill the picture temporarily while you listen to music you will need to access the menu and turn the brightness to minimum.

Samsung... | 190 views | 1 helpful votes


Sounds like an imperfection in one of the layers of the screen, this can be resolved by dismantling the screen and cleaning the layers in a dust free environment...... so in everyday terms this should be done under warranty.

As for water damage.... unless the patch starts from the outer edge of the screen it is highly unlikely to be caused by water damage in my opinion.

Samsung... | 351 views | 1 helpful votes


start by trying to reset your TV. Disconnect the power cord from the outlet, then press and hold the power button on the TV (not the remote), for at least 10 seconds. Then wait a few minutes and plug the TV back in and press power once. 2 blinks on Samsung TV's usually indicates a bad power supply
https://www.samsung.com/nz/support/tv-audio-video/troubleshooting-sound-issues-on-your-samsung-tv/

Samsung... | 82 views | 0 helpful votes


Contact Samsung to request.

Samsung... | 68 views | 0 helpful votes


Could be an open fuse or switch failure rather than a board.

Samsung... | 47 views | 0 helpful votes


It is most likely neither one. The LED strips on the screen have too many failures and the power supply senses the increase and wont come on. You can replace all the strips as a wide approach or you can locate the failures and replace individual items.

Samsung... | 31 views | 0 helpful votes


normally, I don't entertain television fixing questions, because it is impossible to diagnose online. However, I will toss a few things in.

The main board might be faulty, or out of a scrapped set.

Check the back of that board in-situ and see if anything near that IC chip is contacting the television fixing frame.

More likely a voltage regulation on that board, rather than a faulty power supply. You can check output voltages, but only if you know what they are supposed to be?

Unfortunately it is a minefield, posters change every board and don't have a working set. You need all the test equipment and the knowledge of boards at component level and what everything does.

Samsung... | 46 views | 0 helpful votes


if input or source ok possible bad power board

Samsung... | 34 views | 0 helpful votes


just cause your power supply is tested good doesnt make it good it could be a shorted panel or more likely the leds behind it unplug everything except the remote eye mainboard and buttons from the power supply and see if the light stays on if it does then i would look into the led strips also check the flash's i dont remember if samsung has a set amount of flashes = a code

Samsung... | 58 views | 0 helpful votes


If you wish to get some details; check the site linked here. Pull up older posts. https://electronicshelponline.blogspot.com/
Line, faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent.
Screen-shots to defective LCD and Plasma panels are given. You can see and compare to that to your TVs', and can make sure about the fault to an extent.

Samsung... | 51 views | 0 helpful votes


Undo the screws. What do you intend to do when you get the back off? Are you a television engineer?

Samsung... | 26 views | 0 helpful votes


Incorrect board, forgot to plug in the sensor or damaged sensor, power supply fault. Could be anything. Look for a signal on the detector with your oscilloscope.

Samsung... | 27 views | 0 helpful votes

Not finding what you are looking for?
Samsung BD-P1580 Blu-Ray Player Logo

10 questions posted

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76407 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Samsung Televison & Video

  • Samsung Televison & Video

Most Popular Question

player wont play blue ray discs but will

  • Televison & Video
Loading...