20 Most Recent
- Page 2 Questions & Answers
Sub zero refrigerator blinking service
most likely there somewhere freon leaks out. Most common place is evaporator in fresh food section. Thats video how to replace it, but i think you will need call service and let them do it. even if your refrigerator newer than this one on the video, its still the same design of fresh food section, so it will look like it. Thanks, I hope it was helpful.
Lights right side dont work
Power present does not mean the switch is ok. Remove the leads from the switch and set your volt ohm meter to resistance. Depress the switch and see if you have a reading on your meter. If the meter reads O.L. while depressed, the switch is bad.
We have been getting service code 50 for our
Error code 50 means excessive refrierator section compressor run. Possible causes include: dirty condenser, stopped condenser motor, faulty termistor or an evaporator refrigerant leak. If it is a refrigerant leak it usually shows up as frost or water driplets half way down on the back wall. Clear codes by holding the alarm button in for 15 seconds.
Subzero model 532
Fernando is right! Now I will put it in girl terms. The lip of the drawer (lip is at back of the drawer) rests on a white plastic thing. But when you take the drawer out completely, the white plastic thing retracts and just looks like the back of the fridge. So when you go to put the drawer back in, you see nothing to put the lip on. So pull the white plastic thing (it looks like a white plastic rectangle about the size of an envelope) forward and then hook the lip onto it and gently pull the white "augur" (the thing that senses when it's time to make ice) down and slide the drawer back in. My son figured this out from reading Fernando's solution. What a relief! Our model is a 561.
Sub zero refrigerators 632 door won't stay closed
This model doesn't have a standard closure system for the doors, It contains a bar and string system under the doors, some parts may not be available currently but parts could be swapped from one side to the other, I have done it and it works. So you will need to inspect all parts to the door including bushing, gaskets and make sure the unit is square to the floor cause this will cause to door to pop open after closing it. Call Subzero for parts directly to fix this issue at 1-800-350-2676. They can and will point you in the correct dealer for you to get the correct parts you seek. Good luck. I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249
Sub zero leaks water
You need to replace that water line, except it's not on top on a 632. And those weren't available in 1994. Do you maybe have a 590?
Gaskets around doors getting hot
CLEAN CONDENSER COILS FIRST AND SEE IF THE FAN ON THE TOP IS SPINING, IF NOT YOU WILL NEED TO REPLACE CONDENSER MOTOR - COMMON PROBLEM
Not finding what you are looking for?