20 Most Recent
RCA Alarm Clock w/CD Player, AM/FM Stereo & Nature Sounds - Page 3 Questions & Answers
How do you set the time and alarm on the RP5600A
Setting Clock
1. Press SET repeatedly until a clock icon
shows on the display.
2. Press REV or FWD to set the clock
time. The time decrements or
increments will follow by a faster rate
when you press and hold the buttons.
AM or PM icon will also show beside
the time.
3. Press SET when finished.
Setting Wake Time
This unit allows two wake times to be set.
1. Press SET repeatedly on the top of the
unit until you see WAKE 1 or WAKE 2
flashes on the display.
2. Press REV or FWD to set the respective
wake time. The time decrements or
increments will follow by a faster rate
when you press and hold the buttons.
3. Press SET repeatedly until you see no
WAKE 1, WAKE 2 or icon the
display.
Selecting Wake Source
You may be woken up by radio, CD or alarm.
1. If your desired wake source is radio or
CD:
• Wake by radio - select an AM or FM
station (see directions on “Radio”).
• Wake by CD - insert a CD in the CD
compartment. If you want to be
woken up by a specific track on the
CD, press and hold wake up - cd
track on the top of the unit and at the
same time press REV or FWD to select
a desired track.
2. Set a wake time (see above direction).
3. Press WK-1 or WK-2 repeatedly at the
front of the unit to select a waking
mode. Corresponding icon lights on
the front of the unit.
- Wake 1 by alarm
- Wake 1 by radio
- Wake 1 by CD
In case of Wake 2, “2” shows at the
centre of the icons.
Cd player wont eject cd
Try this:
Starighten a paper clip and gently push it into the small hole situated usually just below the tray door until you feel some resistance: continue to push gently and the door should open slightly - enough for you to pull it open and reclaim your disk. Make sure the PC is turned off before you do this. You may then find also that the CD tray will co-operate again when you turn it back on.
RCA Clock Radio with CD
1. Rotate the SELECTION KNOB to the WAKE MODE 1 or WAKE MODE 2 position.
2. Press the right or left arrow button to cycle through the wake modes until the alarm indicator on the display completely disappears.
Car stereo has power but no sound.
remove headunit and check if everything was installed properly. check if the fuse on the headunit isnt blown out. check wiring for speakers, for example for some reason they became loose.
Can't set alarm
Push the center botton on the back until you see WAKE I and then by holding it dwon push the bottons on either the right ir left of that button to set the alarm.... same process for WAKE 2...just have to push the center botton again
ALARM CLOCK SETTING
I've manage to set it... press time/awake and the 1 flashes... use arrows to set the time... then press time/awake again for alarm 2.
But how do you know when it is actually set?? it did not go off this morning and i was late for work!
RCA 3755 won't recognize/play the CD
It could be the laser reader has dropped, causing it to 'lose' the inserted disk. You may need to consult the manufacturer if your warranty is valid, or a local electrical retailer.
ILOST MY MANUAL FOR THE
All I wanted was the instruction booklet for this radio,and no I have not found one,and you're no help
CD player won't work
The system does not work on a certain type of disc that has been copied from another CD
Setting time and alarm clock for timex nature sounds clock
Hold the time set key in until the time flashes. Now let it go and use the tuning forward and back keys to set the time. I had the same problem because I continued to hold the timeSet button down while trying to adjust it. If you do, the forward/back keys have no effect.
Not finding what you are looking for?