20 Most Recent Audiovox BA200 Car Subwoofer - Page 7 Questions & Answers

I had to send my first one in when it did the same thing. I had to suspend my xm service while I waited for Audiovox to decide if they were going to warranty it. It took two months. Now the one they sent me did the same thing! There is no way to fix it according to audiovox you have to send it in.

If it asks for the security code...it means that either you have bought it second hand..and it asks for a 6 digits pin ....and in this case the only simple solution is to call the previous owner...or..if you do not have this posibility ..it will cost you a little ..but on this kinda devices the security is set on the first usage and it is stored in a flash chip that will never can be reset by removing batteries or stuff like that ...and the only way around is to get it to a repair shop and remove the chip ..and put another one ...even second hand if will give you the code..
Another way it may be to contact the manufacturer and give them the serial from the product and they to supply with a backdoor code..that will allow you to get in an change this one ...BUt , I had this kinda problems before and the conclusion was that is cheaper and faster to change the memory chip ..Im not sure what will ask in your area for this operation ...but you just ask ..and if t is worth doing do it ..cause it 's the fastest way ..

try code 8 2 1 2

Hi! I've got my Audiovox ccs-100 installed in my Duna Weekend Diesel car. But it just doesn't work. I don't know if it's because I connected the vacuum to the brake servo or what! Can you help?

do you have the harness for it?

Ford  Code Entry Instructions

Once the unit has been turned on the display will show ' CODE - - - -'

Press preset [ 1 ] repeatedly for the first digit
Press preset [ 2 ] repeatedly for the second digit
Press preset [ 3 ] repeatedly for the third digit
Press preset [ 4 ] repeatedly for the third digit
 
To save the code press the [ 5 ] key to accept.

The set should now operate.

check the batteries in the headphones

A replacement faceplate will work with the rear part and yes you should be able to order one seperately especially as you still have the original receipt albeit only slightly legible.

Regards

Lloyd

These older Holden radios can be awkward to decode

Ask here

www.ukbookshelf.co.uk 

as they are familiar with Holden

Have a look on the Eurovox site

http://www.eurovox.com.au/html/download.htm

Your code is 5917

Ford  Code Entry Instructions

Once the unit has been turned on the display will show ' CODE - - - -'

Press preset [ 1 ] repeatedly for the first digit
Press preset [ 2 ] repeatedly for the second digit
Press preset [ 3 ] repeatedly for the third digit
Press preset [ 4 ] repeatedly for the third digit
 
To save the code press the [ 5 ] key to accept.

The set should now operate.

I'd disconnect it from the car, meaning any power plugs, and wait about 5 minutes to make sure all power has left, and plug it in again. Also, check the front, back, every side of the receiver for a reset button/hole.