Furuno GP31 GPS Receiver - Answered Questions & Fixed issues
Furuno gps gp 32
The only place to get that screen is through a Furuno authorized dealer. The unit is sealed and gas filled to remain waterproof. You're best bet would be to send the unit in to Furuno for repair. You wont save much doing it yourself because the cost of the screen makes up most of the cost of the repair. They will also make sure that all the software is up to date for the new WAAS satellites that recently went on line.
Have you tried adjusting the contrast? On that model I believe you tap the power key while the unit is on and you will see 2 sliding scales on the screen, one for brightness and one for contrast. Up or down arrows select the scale and left or right arrows adjust it. If the contrast and brightmness aren't tied into the power key on that model, they're somewhere in the set up menu.
If adjusting the contrast doesn't help then the screen has most likely failed. This is commonly caused by old age, however repeated exposure to extreme heat or cold can cause premature failure.
Have a furunogp30, problem-isnt showing correct
Hi,
According to your problem, first reset the GPS device. Reset
the antenna. Make sure your position that the antenna can receive the network. So
set the position properly. You may need a firmware update for the device. If it
doesn't solve your problem then you can reload the software of the device. You may
have to replace the antenna. But before that, check the connection of the
antenna properly.
Function of blue nmea wire in Furono GP31
The blue cable is the reférence 0 (ve-) for Receive Data (ve+ yellow wire) and for send data (green wire)
The function is the path return for the data transitting on the nmea bus. If not connected the return is made by the way of the ground of the véhicle if it is connected. othewise the nmea won't work.
It should be équal to the potential 0 Ground (if the ground plug is connected) but it could be a little different. The purpose is to isolate the minus of batterie from the ground, wich is very useful on a metalic vehicle (an aluminum boat for example).
Furuno GP 30-35 GPS
je viens de prendre possession d'un gps furuno 30/35
Jje n'arrive pas a afficher ma route pour allaer d un point a un autre
merci de m'aider
I want to know where the red,yellow,blue,
red and black are power and ground, blue and white are gps output signal connect those to 9 pin connector pins 2 and 5 and get a 9 pin(serial) cable to usb adapter for input to a laptop, charting or mapping program and you are good to go. just make sure if you are using xp to wait until the mapping program is running and searching for gps signal before you connect the serial or usb because windows thinks the signal is from a mouse and the cursor will turn into a raging crackhead jumping all over the screen and randomly clicking on whatever it touches.
I have bought a ICOM VHF m601 and I want to
Using the nmea output from your GP-31 to the nmea input on the VHF. Enable the GLL Sentence and make sure the port is set for nmea0183. Remember hooking nmea up it's positive to positive and neg to neg. Once that is done and you have a fix you should have lat and long on your vhf.
I would like to know what coloured wires connect
Thyere are onlyb two wires red and black red is power black is return and the green earth should not be earthed anywhere on the case. If you need the manual contact me
[email protected]Please nrate my help++++Thanks for using FIXYA
dont rate if you have more questions as it locks me out, use email
Can we connct furuno gp31 to pc
Hello!
Yes, the GP31 can connect to a PC. With the wiring harness, it has an RS-232 port, which allows it to connect to most PCs, laptops, and even most palmtop systems.
Hope this helps you out,
Ken
Not finding what you are looking for?