20 Most Recent
- Page 8 Questions & Answers
After tv is on about 20 minutes, its shuts off and
THis problem is due to overheating..
Check, whether all the exhaust fan is working or u have proper ventilation..
If fan is not working you have to replace the fan
ENJOY! RATE THIS SOLUTION
RNJ VINOD KUMAR
GE Rear Projection TV set with "3D" colors
This is a common problem that was NOT caused by watching the 3D movie! Bad solder connections on the high voltage transformer have caused a solder in fuse to blow. The transformer will have to be resoldered and the fuse replaced.
Sparks and burning plastic
Leave the back off and try to power the set on...be ready to pull the plug. Whatever is sparking/smoking is your bad part. On this TV I would suspect the flyback transformer or grey rectangular polyester capacitor mounted in front of a heatsink on the left.
I replaced the flyback and now I hear a high pitch
hi, where did u purchase the flyback and was it in an oem box with rca/ge or thomson consumer electronics written all over it ? most generic fly`s such as asti, crc, and hr diemen don`t work for **** in rca/ge tv`s, screen control is extremely fussy and must be set exactly or will do exactly what yours is doing, let us know, video-tek
TV turns off on its own - sometimes comes back on, but now just won't come on
Mine did this for about 3-4 months. I would not use this TV any more until you get it fixed. I have been reading and if you have the same problem I had this could catch on fire. Does it make any noise? I just fixed mine, it was a bad solder joint, Unplug the TV and take off the back, about 12 screws. Make sure its dark and plug it in and see if you see any sparks and unplug right away.. Mine did, I re soldered the bad joint and it turn right on. Been on for about an hour now, working perfect!
Does it make any noise? I just fixed mine, it was a bad solder joint, Unplug the TV and take off the back, about 12 screws. Make sure its dark and plug it in and see if you see any sparks and unplug right away.. Mine did, I re soldered the bad joint and it turn right on. Been on for about an hour now, working perfect!
GE D52GW12 52
Most likely bad solder connections around the flyback area of the circuit board, that model is famous for bad solder around the flyback and bad flybacks them selves. But if the led doesnt flash 3 times then go out, its most likely a solder issue.
The colors seperate and there's hour glass shaped lines over the
you have lost convergence in your set. although i find it rare to have the fl231 fuse problemon this old ge model i always check to see if that the first thing at the shop. there is a article intitled fl231 problem in tips and trick section. the next thing will be the convergence power supply. if yu have the convergence option in the setup of customer menu under red or blue convergence can you move the crosshairs
Not finding what you are looking for?