Humminbird NS25 GPS Receiver - Answered Questions & Fixed issues
Gps ns25
The wiring within the Screen unit seems to be very poorly done, there are 4 cables to the GPS side of things and these can contact each other as there is a portion of the wire where it enters the connector that is bare, and if these touch one another then you will get nothing.
Dismantle the head unit and check the cables, i would be inclined to shrink wrap the bare portion of each cable.
Hope that this helps, it might not be the answer, but it is worth checking.
adrian.
Gps ns25
Please check the mount and the wiring throughly as its a loose contact issue nothing else.
Moisture in antena
Hello there.
Please click
here to find a replacement antennae for your Humminbird device.
Hope this helps.
Humminbird NS25 GPS
This is a common problem on lots of boats with any brand of electronics. Most likely it is being caused by a bad crimp in a wire connector, or by having too many connectors on a terminal in the power supply bus. Start at the power supply source and ground and replace any butt or terminal connectors with high quality heat shrink connectors (such as Ancor). Make sure that the connector is the right size for the wire.
On Humminbirds the problem could also be in the swivel mount that holds the power and data cables. The cables should be held in place by a metal bracket which is located under a panel held onto the swivel bracket by to small philips head screws. If any of those components are missing, the plug may be loose in the socket which could cause it to disconnect temporarily when the boat hits a wave. While you have it apart check the plug and the socket for corrosion.
I hope this helps. Please contact me if you have any more questions.
Portable Humminbird 565
I've got the 565 and everything will be working fine and then the depth
finder or bottom of the lake goes to 6ft. Have to shut it off for an hour and it works for a wile but it always goes back to doing it
anything I can do?
Thanks Jeff
6/8/2013 4:31:12 PM •
Humminbird GPS
•
Answered
on Jun 08, 2013
•
244 views
Need to locate and print
print users manual for Humminbird Pironha Max 160 Fish go to this link
http://store.humminbird.com/media/document/PiranhaMAX_150-160-170-180-190c.pdf
9/7/2012 2:30:06 PM •
Humminbird GPS
•
Answered
on Sep 07, 2012
•
409 views
I getting ready to order
It does come with everything in the box you need to rig your boat. If you are going to rig it on a fiberglass boat I would mount the Side Imaging transducer right under the jackplate and make sure you can see from side to side without anything blocking it on either side of the transducer. Then I would epoxy a transducer (XP 9 20) in the hull of the for high speed readings and then use a Y cable (AS SIDB Y) to tie the 2 transducer together.
1/3/2011 4:19:21 PM •
Humminbird GPS
•
Answered
on Jan 03, 2011
•
512 views
Humminbird fishfinder keeps blowing 5v
Hi,
Most probable component that has gone bad and capable of blowing the 5V fuse would be:
- voltage regulator IV or transistor;
- reverse protection diode;
- zener diode;
- shorted capacitor.
As the 5VDC normally supplies the logic circuitry, perhaps diagnosis and tests should be focused within that area.
Hope that this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
10/24/2008 9:55:35 PM •
Humminbird GPS
•
Answered
on Oct 24, 2008
•
847 views
My Conlog Prepaid electricity Meter is showing a spanner and not bring in light. What should I do?
Question edited for clarity. It is 'Conlog', not 'cinlog'.
It means there is a technical fault. Phone the company that supplies your electricity. It is their meter and distribution network.
What are the causes of a spanner appearing on ...
Quora
https://www.quora.com > What-are-the-causes-of-a-spa...
Jul 15, 2023 - A spanner icon anywhere indicates a need for maintenance. If the light is orange, get the service as soon as. If the light is red, call a ...
3 answers · 6 votes: Spaaner that appears on any equipment is the symbol of due for maintenance. Follow the OEM ...
Help! My Prepaid Meter Is Showing A Spanner Icon.
Nairaland
https://www.nairaland.com > prepaid-meter-showing-spa...
Mar 7, 2022 - I noticed my neighbours still had. On getting outside to check the conlog ip54 prepaid meter, I saw a spanner icon and a negative reading of the energy balance.
Please Help With My Conlog Prepaid Meter - Technology Market
Aug 6, 2020
I Need A Technician To Fix This... - Nairaland / General - Nigeria
Jul 22, 2019
Please Help With Conlog Prepaid Meter - Technology Market
Oct 9, 2022
Help My Prepaid Meter Stopped Displaying! - Nairaland Forum
Aug 3, 2023
More results from www.nairaland.com
..
3/8/2024 9:09:19 PM •
GPS
•
Answered
on Mar 08, 2024
•
24 views
Not finding what you are looking for?