20 Most Recent Kenwood 1080VR Receiver Questions & Answers

u try new bateries alkiline ones if that aint it we can get u new remote at www.remotewarehouse.com ok

use a rca video cord one end to the video out from the kenwood other end to your tv. with your remote push setup and ajust the db levels. the higher the db levels the quicker protection will shut you down mr. pepsi

Hi Jay,
This kind of trouble was caused by leaky/dried electrolytic filter capacitor in the power supply section and or bad solder joints. You must have a capacitor checker to determine the condition of capacitor to isolate the faulty one. Also check for bad solder joints around the power supply section. This is hard to spot, I would advice you to work in the brightest area or used portable/table lamp. If you don't have necessary tools and test instrument, I would advice you to look for a qualified technician to troubleshoot the symptom.
Hope I helped you. Have a nice day! Thanks for using Fixya.

Welcome to Fixya! It sounds like the Reciever is getting too hot and shuuting down. Have you checked the Cooling fan inside to see if it is working?

I had this problem! It was the Cars Battery. Kenwoods unit's fade or go completely blank when there is little power to power the stereo. Try charging your battery or grabing a new one from a scrappy! I was all over the net looking for help but finally sorted it!

P.S. My younger brother had to do the exact thing and it worked for him as well!!!

CHECK THE FRONT OF YOUR AMP FOR A SET UP BUTTON OR MENU BUTTON,THIS SHOULD LET YOU SET UP YOUR SUB AGAIN.

HOPE THIS HELPS
CABLE GUY.

try unpluging it all plug in sumware else see if it just turns on

Back when these were made, USB was either not invented or in its infancy. Sorry, too old for USB.

Probably not but a universal; One For All will when programmed.

There is a KX-328 and there is a KX-32B and visually at a quick look, they may look the same. The procedure is similar though. https://www.google.com/search?q=kenwood+kx-328+cassette+deck+drive+belt+replacement ,,

The first thing to check is the solder connections on the display itself. The display should have a series of pins that you will see on the PC board that is behind the front panel. Resolder the connections on either end. These are the connections that supply both the +and - sides of power. These often develop poor connections. Update this with the results of the resoldering and we'll continue from there if the problem is not resolved.

Dan

Check the Remote Control: Ensure that the remote control is functioning correctly. Press the MUTE button on the remote control to unmute the sound. The "MUTE" indicator should turn off. Manual Adjustment: Navigate to the receiver's setup menu and locate the audio settings section. Adjust parameters such as bass, treble, balance, and surround sound modes to achieve your desired audio quality. Physical Connections: Verify that all audio cables are securely connected to the appropriate inputs and outputs. Check if any cables are damaged or loose. Speaker Configuration: Make sure your speakers are correctly configured. If they are set to "Mute", unmute them. Factory Reset: Refer to the instruction manual for instructions on performing a factory reset.

No, you must press mute again on the remote to toggle off mute.

You could put a peice of gaffa tape over the sensor window if you do not read schematics very well.