if it's the walking belt, make sure that the rear roller is parallel to the back of the walking board. Sounds goofy, stand on the mill looking back away from the front of the display. Look down to where the walking belt goes around the roller, the roller should be parallel to the walking board.
How to Replace an Elliptical Console
Please see the video, and follow the steps.
However clean very well the spring with electronic cleaner contacts, and see if the wires are o.k or loose or desolder and repair.
Use ALKALINES batteries for Heavy duty.
Blessing.
[email protected]
cell+whatsAPP:+50588611441
1) Please use electronic spray for electronic and LUBE the small POT in the electronic Board.
2) Adjust the Speed sensor, and test it, and see is ok or faulty, clean it and ajust 1mms near of magnet. otherwise replace it.
Blessing
[email protected]
cell+whatsAPP:+50588611441
Eletric treadmill Speed Sensor Adjustment
You must take out the cover, and examine if there
are part with lack of LUBE, and corroded.
Normally this happen because the equipment has NOT maintenance in the time, determined by the factory.
Proceed according. LUBE.and repair
Blessing
[email protected]
cell+whatsAPP:+50588611441
there 3 things that you observe:
1) The walking belt is too Tight, the deflection will be 2-3" when you lift with his finger.Adjust the https://www.youtube.com/watch?v=XyPedy7HtzM
2) the thermic swithc of the motor Tripp for the tension of walking belt.
3)the driving belt of belt motor too tight. Deflection will be 1/8" loose the bolts of motor, and adjust.
Blessing.
[email protected]
whatsApp:+50588611441