20 Most Recent DeLonghi ESAM3500 Espresso Machine & Coffee Maker - Page 7 Questions & Answers

Most likely the heating element would have to be changed the water will not come out till it reaches its temperture

I'm not sure about your specific machine, but in general: Make sure you have the correct size and shape filter, measure carefully so as not to overfill, check that the grind is not too fine and plugging the filter. This can cause the filter to overflow and grounds float into the pot.

http://www.fixya.com/support/t11896966-delonghi_eco310_replace_steam_knob https://www.quenchessentials.com/delonghi-eco310-icona-manual-espresso-machine.html

https://www.youtube.com/watch?v=uOF9FL3HQeU

http://www.fixya.com/support/t26188048-delonghi_machine_says_empty_grounds

http://kavegepbolt.hu/shop_ordered/9160/pic/Saeco/DELONGHIESAM5500.pdf

The 'o' rings that come on the steam wand at purchase are rubbish. They come off easily without you even noticing when you remove the parts for cleaning after each frothing. The replacement o rings from DeLonghi do the same thing. I eventually went to my local coffee machine repair shop and got an o ring from them. It has never come off in the year and a half since. . . . . and I have no problems with my Magnification S. Now I LOVE my coffee machine!!!!!!

https://m.youtube.com/watch?v=mM5PRiOD8jI

If spout pops out it may be clogged - clean spout with compressed air and small wire run all the way thru the spout. Additional help at this link "https://www.6ya.com/philip_b05beb373d913f26"

This is a step by step of how to make a 8oz cup of cofee: https://www.youtube.com/watch?v=FOCLtmsLSIY

Dod you close the valve for the steam to escape and is there enough milk in the frother compartment?

The problem is not the main board, but the motor of the machine. This one is pulling a short circuit when it's spinning. Please replace this.

Your idea should be correct. Check all the wiring of the sensor when you removed the top of the machine. The sensor should be there somewhere underneath. If the wires are correct and the rest is not working properly, please contact delonghi for a spare part

Make sure that he floater in the water tank is loose and moving. If that is so, then the machine will register again that the water bucket is there and filled.

It sounds like the machine is broken and needs to be returned to the retailer. You are still in warranty for this.

Try the following: https://cremacoffeegarage.com.au/blog/delonghi-coffee-machine-troubleshooting-infuser-stuck

This indicates that there is a bursted pipe somewhere in the machine. If you have warranty still on it, bring it to the retailer. If do no not have any warranty left on it, try to find the broken pipe yourself. CAUTION! This is dangerous and you can get an electric shock or even electrocute yourself when you open these machines for repair. Please visit a repairshop if you dont want to replace it yet.

It seems to be the one way valve which is broken. You can buy those from ebay by looking for "one way valve" Since this is an advanced repair, I can't tell you everything in case of damage done to yourself while trying to repair the machine.

Try running vinegar through machine 2 times. I would not ruse vinegar that came through machine. Now run 1 carafe of water through to rinse it out. Now try making coffee.

Switch off and remove the main capsule. Stand it in warm water for 10 minutes then check it over before reinserting. Switch machine back on and u should be good to go.