20 Most Recent
Raymarine RL70CRC GPS Receiver Questions & Answers
Keeping course
Please check if the pilot is acting the right direction ,press +10 key and check if boat teers STB,
press -10 and check if boat turns PORT ,if it acts reverse, see handbook to reverse action.
Verify if compass course in standby is indicating correct course .
Do the calibration procedure as stated in in the handbook (360 degree turn)
If it still not indicate the correct course ,or is frozen, compass or printed circuit is faulty.
Check the resistance between the wires of the compass unit .(see google internet)
Good luck
Jean
1/30/2023 5:37:33 AM •
Raymarine...
•
Answered
on Jan 30, 2023
I got a raytheon sl70 pathfinder gps that wont get
If you're using a raystar 125 antenna, you will have to power the red wire + and the shield wire - separately. Sl70's don't provide power over seatalk. Also make sure your green and brown wires are properly connected. If it's a 120 just power the red and sheild(black) and leave off the all except the yellow that's your data. If you still have nothing may probably have a problem in the antenna itself.
8/31/2021 1:06:33 PM •
Raymarine...
•
Answered
on Aug 31, 2021
HOW TO DO MASTER RESET
Welcome to FixYa!
Factory Master Reset: This resets all values back to their original factory settings.
CAUTION: The factory reset clears the Marks database, and the chartplotter Waypoints and Routes databases.
To perform a factory reset:
- 1. Press MENU.
- 2. Press the SYSTEM SET UP soft key to display the System Set Up page.
- 3. Press and hold MENU for 5 seconds.
- A countdown timer is displayed. If you release the MENU key before the timer reaches zero, the reset is not performed.
- When the reset request has been accepted, the system restarts.
Thank you for using FixYa.
Have a great day.
Jas247
7/28/2011 6:31:19 PM •
Raymarine...
•
Answered
on Jul 28, 2011
I have a RL70CRC display that's locked in some
Hi,
It is due to component failure you are getting this error . For hardware reset you need to disassembe the unit and reset the accessible connectors. Also check all connectors are connected properly without any loose connections .
It involves risk in opening device ,if you prior experience in working on electronic items then you go with disassembling and accessing the connector .
Hope this helps .
If you have any queries ,feel free to ask .
6/7/2010 11:53:09 PM •
Raymarine...
•
Answered
on Jun 07, 2010
Can you shorten a radar cable
No you should not, it is made in a thing called "Wave Lengths" it is made to be a special number of WL long to avoid and stop "Reflections" of the signal. I guess if you can find a formula that you can calculate the exact length, then you could do that i guess.
4/10/2010 9:46:23 AM •
Raymarine...
•
Answered
on Apr 10, 2010
Not finding what you are looking for?
