You aren't a dealer or technician so you don't get to have one. I can sell you one, [email protected]. You remove the no spam when you type it obviously
There are only a few ways for oil to be leeking1. Crank housing gasket (most likely culprit)2, Rubber O-ring on filler cap3. Rubber seal fitting to Oil pump inlet.4. Crack in the crank housing
`It could well be the carb flooding, however if you have been cranking the engine for a time without it starting it will keep drawing fuel into the cylinder, you need to remove the spark plug, switch the on/off switch to off, make sure the choke is off, crank the engine until no more fuel comes from the open plug hole, now leave with the plug out to allow it to dry out, refit the plug and try to start with no choke and wide open throttle.
hello sir, the gas / oil ratio is, 3/4 o/z per quart or 2.6 o/z per gallon of two cycle oil, any two cycle oil will do,this is how i mix mine and never had a problem,it is a good mix.hope this helps,don't forget the 4 thumbs up,any comments welcome,thank you. ~~
Suggest a cranckcase leak test to locate leak(s) other than rings. You need to seal the intake and exhaust ports and pressurize the crankcase via spark plug hole. No special tools other than an adapter from sparkplug hole to compressed air. The intake and exhaust ports can be sealed with pieces if old bicycle inner tube between carb and port and muffler and port. Then apply 5 to 10 psi to spark plug adapter. Spray case seams and shaft seals with WD40 or soapy water to locate slow leaks.Search "two cycle crankcase leak test" for videos.
I have been trying to find a new Trimming head for my Stihl FE 55 for about 4 years now, with no success. A British company say that their part no. 400471021932 fits my machine. I'm in South Africa but, and need to source one here.
It is a fuel / air problem. Do you have a primer bulb, did you replace it and put it in the right way around arrow to the carb? It is a known issue. There are lots of help online and there are some videos below..
JustAnswerhttps://www.justanswer.com > small-engine > 2otj1-sti...
Oct 22, 2009 - cub cadet self propelled mower starts up fine runs for about 5 min. then dies. Will start again after several pulls then dies again 4-5 min.
1 answer · Top answer: 3 real options. I will start with the easy one. 1. Your gas cap could be not venting correctly. ...
