Sony KP-53S65 53" Rear Projection Television - Answered Questions & Fixed issues


The value of C514 is 390PF 2kv

Sony KP-53S65... | Answered on Jan 21, 2018 | 85 views


It probably was a bad product. Call sony and they should send you a replacement depending on how old your product is.

Sony KP-53S65... | Answered on Dec 17, 2012 | 44 views


A rather older set:

picture blinks may be screen controls now set too low

picture dark same or lens need cleaning

color off either adjustments or a Convergence issue

Sony KP-53S65... | Answered on Mar 17, 2012 | 61 views


Trace the voltage to the main board and you must be able to confirm that the +B to the board is in order. since there is sound the front end sections are in order and the fault relates to a failed drive or video process.
Check the power to the lamp circuits if there is no output this is the area to trace.
if there is glow on the screen then there is absence of video output drive and it needs a trace. use of signal tracing and injection might be needed or you must get help to confirm before any board or costly spare is changed.

Sony KP-53S65... | Answered on Nov 07, 2011 | 33 views


EY34 is a location near a small blue capacitor that commonly burns up; Location number for the cap should be C514 and the values of it are 1,000 pf (pico farad) at 2 KV (2,000 volt rated).

Often if it is burnt it is the only problem and both Hitachi and Sony used the same identical part in several of their sets.

Let me know if you have questions.

sd tech

Sony KP-53S65... | Answered on Sep 25, 2011 | 77 views


mine also does the same so any suggestions would be helpful.

Sony KP-53S65... | Answered on Sep 13, 2011 | 23 views


try replacing your lamp and also resenting your timer make sure to get a Philips lamp and if you kneed a ballast try calling discount merchant they are very good and have original lamps also they trouble shoot any problem you may have with your dlp

Sony KP-53S65... | Answered on Sep 13, 2011 | 44 views


Does the front light blink any kind of pattern?

Sony KP-53S65... | Answered on Aug 18, 2011 | 29 views


Sounds like convergence problem. Fixing the problem requires removing, desoldering and soldering the convergence ICs.
The repair for this may go for a couple Hundred or more..
Best of luck
Nour Sabre
WWW.AAATVSERVICE.COM

Sony KP-53S65... | Answered on Jul 29, 2011 | 49 views


U must have tools like a soldering iron,a roll of solders,a roll of desoldering braid or a desoldering pump and must have basic skills of doing soldering works?Yes,than tries these 2 websites like Tvrepairworld.com,Tvrepairkits.com to buy a whole tv convergence kit belong to ur tv make and model.The complete convergence kit will came with all and the most common components parts are dying and dead on ur tv make and model in the tv convergence board also with the kit is a tutoring DVD disc.Have no tools and never done soldering work before.Tries this repair at ur own term,after u finish could have complication might not solved ur tv convergence picture problems at all or completely.Or the shop will cost like $300-350 for parts and labors.

Sony KP-53S65... | Answered on Jul 18, 2011 | 42 views


Hi,

The Standby/Power light of the TV blinks when there is any internal malfunction in the TV. The self-diagnostic function of the TV will cause the STANDBY light to blink or flash when the television detects an issue. The number of times the STANDBY light flashes corresponds to a specific issue.

Few examples are given below; some of the issues may be resolved without the need for service.
1 blink / 2 blinks / 5 blinks: - This indicates that there may be a power-related problem with your set.
3 blinks: - This indicates that there may be a power-related problem with your set. The set will need to be serviced to allow a technician to determine the specific issue that needs to be repaired. If the power light flashes three times in sequence in a Lamp TV, the lamp cover is not securely attached. Reattach the lamp cover to resolve this issue.
4 blinks: - This indicates that there may be a back light or lamp power problem.
6 blinks: - This indicates that there is some kind of audio problem with your set.
7 blinks: - This indicates that there is a temperature problem with your set. Please check to make sure that the air vents on the sides and back of the set are not blocked or clogged and there is adequate ventilation around the television. We recommend that you check and clean the vents periodically to make sure the set receives adequate air flow. If the problem continues, the set will need to be serviced.
8 blinks: - This indicates that there may be a video-related problem with your set. If the flash sequence is not listed above or the light continues to flash, follow the steps below to perform a power reset:
Try the following steps to check if the issue can be resolved.
Turn off the television.
Unplug the television power cord from the electrical outlet.
Let the television remain without power for 60 seconds.
Plug the power cord back into the electrical outlet.

If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.

If the issue continues to occur, service may be required.


Thanks for using Fixya.

Sony KP-53S65... | Answered on Jun 12, 2011 | 83 views


Hi,
The Standby/Power light of the TV blinks when there is any internal malfunction in the TV.
The self-diagnostic function of the projection TV will cause the STANDBY light to blink or flash when the television detects an issue. The number of times the STANDBY light flashes corresponds to a specific issue. As per the two examples below, some of the issues may be resolved without the need for service.
If the STANDBY light flashes three times in sequence, the lamp cover is not securely attached. Reattach the lamp cover to resolve this issue.
If the STANDBY light flashes four times in sequence, the TV may be overheating. To resolve this issue, ensure that the back of the TV is well ventilated.
If the flash sequence is not listed above or the light continues to flash, follow the steps below to perform a power reset:
Try the following steps to check if the issue can be resolved.
Turn off the television.
Unplug the television power cord from the electrical outlet.
Let the television remain without power for 60 seconds.
Plug the power cord back into the electrical outlet.
If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
If the issue continues to occur, service may be required.

Thanks for using Fixya.

Sony KP-53S65... | Answered on Jun 08, 2011 | 301 views


You would need another cable box to watch a different channel on the secondary picture. If you can hook up another cable box then that one will plug into the secondary input.

Sony KP-53S65... | Answered on May 05, 2011 | 49 views


try MCM electronics or Suburban electronics. The main thing is you want a capacitor rated at 390uF with a working voltage of 2000V. Take note of the size and orientation of the part. You don't have to buy the part from Sony, you just need to know what you are buying if that makes sense.

Sony KP-53S65... | Answered on Mar 26, 2011 | 31 views


my advice is to call sears. I had mine fixed for $300. they charge $99 to come out and get the estimate and decide from there

Sony KP-53S65... | Answered on Dec 19, 2010 | 23 views


Hello, first make sure the red horizontal and vertical adjust do move(up/down, right/left) sometimes the pico fuses open and that is why one color does not align. If the pico fuses are not the problem reset the red adjustment as much as you can to their mid settings and adjust the centering rings on the red CRT to converge in the middle of the screen, then try your dyn. convergence again, this should get the red to converge.

Sony KP-53S65... | Answered on Dec 04, 2010 | 79 views


popping noise is a power supply problem.

Sony KP-53S65... | Answered on Oct 24, 2010 | 151 views


hello well it's and old tv, my guess it could be capacitors in the power supply or even dry joints on the power supply board, it would be best to have someone with electronic experience to have a look at it

regards
shaun

Sony KP-53S65... | Answered on Oct 07, 2010 | 443 views


mrrcody56,

If you have a picture, but only in green, I would try turning up the drive for the red and blue guns. They have probably changed and need a boost. This does mean that the CRTs are dying and may not have too much time left.

To turn up the drive first remove the back cover on the bottom. You will have to work on this unit live so be very careful and do not touch anything other than what I tell you.

Look at the space above the main circuit board. Somewhere across the beam supporting the CRTs you will see a square box with 6 controls (shafts). You can locate the box if you follow the wires from the flyback to the box. The flyback is located on the right rear corner and produces the high voltage. It will have 4 large red rubber wires coming out of it. Three go to the focus divider block (the box in question) then they go on to the crts (red, green, blue).

Once you locate the focus divider look at it closely. The focus controls are on top and the drives are on the bottom. They should be marked red, green and blue. You want to turn up the red and blue. Tune a picture with as much black as possible. While watching it turn up the red until you see a red tint or streak then turn down until it just disappears. Do the same with the blue. You may want to touch up the green also.

If the set is working OK your picture should look normal.

Thanks for using FixYa and for the generous rating.

hardrocko

Sony KP-53S65... | Answered on Sep 21, 2010 | 73 views

Not finding what you are looking for?
Sony KP-53S65 53" Rear Projection Television Logo

130 questions posted

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76466 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Nasir Muhammad
Nasir Muhammad

Level 2 Expert

230 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...